JVC LYT1805-001A Benutzerhandbuch

Seite von 108
1
 EN
Getting Started
Power
Charging The Battery Pack
1
  Set the Power Switch to “
OFF” ( 13).
r
 Arrow
BATT.
AC Adapter
To AC Outlet
(110V to 240V)
Battery 
Pack
POWER/CHARGE 
Lamp
2
  Attach the battery pack. 
• 
With the “
r
” (arrow) on the battery pack  
  pointing at the correct direction, slide the  
  battery pack until it locks in place. 
3
  Connect the AC adapter.
• 
The POWER/CHARGE lamp on the 
camcorder blinks to indicate charging 
has started.
•  When the POWER/CHARGE lamp goes 
out, charging is finished. Unplug the AC 
adapter from the AC outlet and disconnect 
the AC adapter from the camcorder.
To Detach The Battery Pack
Slide the battery pack while pressing 
BATT. to 
detach it.
Charging/Recording Time (approx.)
Battery pack
Required 
charging time
Maximum 
Continuous 
Recording 
Time
BN-VF808U 
(Provided)
1hr. 30 min.
2 hrs.
BN-VF815U
2 hrs. 40 min.
4 hrs. 5 min.
BN-VF823U
3 hrs. 50 min.
6 hrs. 10 min.
Notes:
•  If a fully charged battery pack is attached to 
the unit, 
POWER/CHARGE
 lamp will blink for 
approx. 10 seconds before it turns off.
•  If the battery operation time remains extremely 
short even after having been fully charged, the 
battery is worn out and needs to be replaced. 
Please purchase a new one.
•  Since the AC Adapter processes electricity 
internally, it becomes warm during use. Be 
sure to use it only in well-ventilated areas.
•  After 5 minutes have elapsed in Record-
Standby mode with the cassette inserted and 
no operation is performed, the camcorder 
will automatically turn off its power supplied 
from the AC adapter. In this case, the battery 
charge starts if the battery is attached to the 
camcorder.
•  Please do not pull or bend the AC adapter plug 
and cable. This may damage the AC adapter.
Using The Battery Pack
Perform step 
2
 in “Charging The Battery 
Pack”.
Notes:
•  Recording time is reduced significantly under 
the following conditions: 
•  Zoom or Record-Standby mode is engaged 
repeatedly.
•  The playback mode is engaged repeatedly.
•  The LED Light is used.
•  Before extended use, it is recommended that 
you prepare enough battery packs to cover 3 
times the planned shooting time.
To DC 
Connector