Epson R-D1 Benutzerhandbuch

2

2

2

2

2

2

2

2

2

2

4.

Focus on the subject and identify the length between the camera 
lens and the subject.

5.

Set the corresponding aperture value from the length and aperture 
list. For the list of the length and aperture value, see the flash unit 
manual.

6.

Rotate the aperture ring to select the desired value.

7.

Focus on the subject again and press the shutter-release button 
down.

You can select whether to store photos with sequential numbers. 
1.

Select Sequential Numbering in the Basic Setup menu using the 
JOG dial, and press the ENTER button. For details on using the 
menu, see “Basic Setup menu” on page 40.
The Sequential Numbering screen is displayed. 

2.

Use the JOG dial to highlight On or Off, and press the ENTER 
button. The new setting is saved and the screen returns to the Basic 
Setup menu.

You can check the statuses of the following four factors: the number of 
remaining photos, photo quality, remaining battery power, and white 
balance using the needle indicator on the top of the camera. There are 
4 needles on the indicator to indicate the statuses of these factors. If any 
of these needles becomes inaccurate, follow the steps below to adjust it.

1.

Select Calibrate Needles in the Camera Settings menu using the 
JOG dial, and press the ENTER button. The Needle Calibration 
screen is displayed. For details on using the menu, see “Camera 
Settings menu” on page 39.

On  (default)

The sequence of numbers continues even 
when the memory card is replaced.

Off

The sequence of numbers is reset and a 
new sequential number is given when 
replacing the memory card.