Fujifilm FinePix A205 Benutzerhandbuch

Seite von 43
31
Advanced 
Features
30
1
2
PHOTOGRAPHY MENU OPERATION
1 Press the “MENU/OK” button to display the menu.
2 Press “d” or “c” to select the menu item and
“a” or “b” to change the setting.
3 Press the “MENU/OK” button to confirm the
selection.
When you enable the setting, an icon appears in
the top-left corner of the LCD monitor.
!
The settings available in the menu screen vary depending on
the Still photography mode.
0
1
0
2
0
3
PHOTOGRAPHY MENU
STILL PHOTOGRAPHY MENU
✽ SELECTING a AUTO /s MANUAL (➡P.29)
Use the table below as a guide for selecting the
best setting.
QUALITY SETTINGS IN STILL PHOTOGRAPHY MODE
!
The numbers to the right of each setting show the number of
available frames.
!
When you change the quality, the number of available frames
also changes (
➡P.21).
Printing at A4 or A5 size or printing part of the image cropped at A6 size.
Quality mode
3
3 MB (2048 
× 1536) 
✽ FinePix A210 only
Best for A6 or A5 size prints.
2
2 MB (1600 
× 1200)
Best for A6 size prints.
1
1 MB (1280 
× 960)
For an image attached to E-mail or used on a website.
`
0.3 MB (640 
× 480)
Sample Uses
1
The self timer is used in situations such as group
shots where the photographer is included in the
shot.
Setting the self-timer to “ON”, “
*
” appears on the
LCD monitor.
In this mode, a timer runs for roughly 10 seconds
before the shutter is released.
1 Position the AF frame over the subject.
2 Press the Shutter button down halfway to focus
the shot.
3 Without releasing the Shutter button, press the
button all the way down (fully pressed) to start
the self-timer.
Beep
1M
A
   33
   33 
2
0
1
0
2
0
3
SELF-TIMER PHOTOGRAPHY
!
The self-timer is automatically switched off in the following
situations:
i When shooting ends
i When the camera is switched to“a” or “s” mode
i When the Mode switch setting is moved to another setting 
i When the camera is switched off
!
The AF/AE lock can be also used (
➡P.22).
!
Take care not to stand in front of the lens when you press the
Shutter button as this can prevent the correct focus or
brightness (exposure) being obtained.
The self-timer lamp lights steadily for roughly 5
seconds and then blinks for another 5 seconds,
after which the shot is taken.
A countdown is displayed on the LCD monitor
indicating the time remaining until the picture is
taken.
Self-timer mode is automatically cancelled after
each shot.
3
4
!
To stop the self-timer, once it has started running, press the
“BACK” button.