Samsung SNC-L200(W) Benutzerhandbuch

Netcam(W)_SNC-L200(W)

Netcam(W)_SNC-L200(W)

This symbol indicates high voltage is
presentinside. It is dangerous to make
any kind of contact with any inside part
of this product.

This symbol alerts you that important
literature concerning operation and
maintenance has been included with
this product.

To prevent damage which may result in fire or electric shock hazard, do not expose this

appliance to rain or moisture.

This device complies with part 15 of the FCCRules. Operation is subject to the following two

conditions.
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may cause

undesired operation.

Class B
NOTE :
This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation.

This equipment generates, uses and can reaiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does not cause harmful interference radio or

television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures :

- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit defferent from that to which the 

receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer ’s instructions.

This equipment complies with FCC RF Radiation Exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a
minimum distance of 20cm between the radiator and your body. This transmitter must
not be co-located or operating in conjunction with any other antenna or transmitter.

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings.

Install in accordance with the manufacturer ’sinstructions.

8. Do not install near any heat sources such as radiators, heat registers, or other apparatus

(including amplifiers)

that produce heat.

9. Do not defeat the safety purpose of the polarized or grounding-type plug.

A polarized plug has two blades with one wider than the other. A grounding type plug has

two blades and a third grounding prong. The wide blade or the third prong are provided for

your safety. If the provided plug does not fit into your outlet, consult an electrician for

replacement of the obsolete outlet.

10. Protect the power cord from being walked on or pinched particularly at plugs,

convenience receptacles, and the point where they exit from the apparatus.

11. Only use attachments/accessories specified by the manufacturer.

12. Use only with cart, stand, tripod, bracket, or table specified by the

manufacturer,or sold with the apparatus. When a used, caution when moving

the cart/apparatus combination to avoid injury from tip-over.

13. Unplug this apparatus. When a cart is used, use caution when moving the

cart/apparatus combination to avoid injury from tip-over.

14. Refer all servicing to qualified service personnel. Servicing is required when the

apparatus has been damaged in any way, such as power-supply cord or plug is damaged,

liquid has been spilled or objects have fallen into the apparatus, the apparatus has been

exposed to rain or moisture, does not operate normally, or has been dropped.

THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT.? SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO
OPERATE THE EQUIPMENT.

2

3

Declaration of Conformity to R&TTE Directive 1999/5/EC
This equipment fulfils the R&TTE directive(Council Directive 1999/5/EC).
- European States qualified under wireless approvals:

EU

Austria, Belgium, Denmark, Finland, France (with frequency
restrictions), Germany, Greece, Ireland, Italy, Luxembourg, The 
Netherlands, Portugal, Spain, Sweden, and the United Kingdom

Accept EU

Iceland, Liechtenstein, Norway, and Switzerland

- European States with restrictions on use:

EU 

In France,the frequency range is restricted to 2446.5-2483.5 MHz for
devices above 10 mW transmitting power such as wireless.

Accept EU  

No Limitations at this time.