JVC GR-D775U Benutzerhandbuch

MasterPage: Start_Right

The audio track can be customized only when 
recorded in the 12-BIT and SP modes. 
(

●

Use the provided remote control. 

Play back the tape to locate the point where 

editing will start, then press PAUSE (

8).

While holding A. DUB (

) on the remote 

control, press PAUSE (

8). The “8 ” indicator 

appears.

Press PLAY (

3), then begin “narrating”. 

Speak into the microphone.

●

To pause dubbing, press PAUSE (

8

).

To end Audio Dubbing, press PAUSE (

8), 

then STOP (

7).

To hear the dubbed sound during playback
Set “NARRATION” to “ON” or “MIX” 
(

●

Sound is not heard from the speaker during 
Audio Dubbing.

●

When editing onto a tape that was recorded at 
12-BIT, the old and new soundtracks are 
recorded separately.

●

If feedback or howling occurs during TV 
playback, move the camcorder’s microphone 
away from the TV, or turn down the TV’s volume.

You can record a new scene into a previously 
recorded tape, replacing a section of the 
original recording with minimal picture 
distortion at the in and out points. The original 
audio remains unchanged.

●

Use the provided remote control.

●

Before performing the following steps, make 
sure that “TIME CODE” for “DISPLAY” in both 
Recording and Playback Menus is set to “ON”. 
(

●

Insert Editing is not possible on a tape recorded 
in the LP mode or on a blank portion of a tape.

Play back the tape, locate the Edit-Out point 

and press PAUSE (

8). Confirm the time code 

at this point. (

Press REW (

1) until the Edit-In point is 

located, then press PAUSE (

8).

Press and hold INSERT (

) on the remote 

control, then press PAUSE (

8). The “8 ” 

indicator and the Time Code (min.:sec.) 
appear and the camcorder enters Insert-Pause 
mode.

Press START/STOP to begin editing.

●

Confirm the insert at the time code you checked 
in step 

1.

●

To pause editing, press START/STOP. Press it 
again to resume editing.

To end Insert Editing, press START/STOP, 

then STOP (

7) on the remote control.

●

Program AE, Effects and Shutter Effects 
(

being edited during Insert Editing.

●

During Insert Editing, the date and time 
information changes.

●

If you perform Insert Editing onto a blank space 
on the tape, the audio and video may be 
disrupted. Make sure you only edit recorded 
areas.

●

During Insert Editing, when the tape moves to 
scenes recorded in the LP mode or a blank 
portion, Insert Editing stops.

GR-D775US_EN.book  Page 45  Friday, December 15, 2006  11:14 AM