Sony DSC-HX300 Benutzerhandbuch

Seite von 68
GB
30
On the overheat protection
Depending on the camera and battery temperature, you may be unable to record 
movies or the power may turn off automatically to protect the camera. 
A message will be displayed on the screen before the power turns off or you can no 
longer record movies. In this case, leave the power off and wait until the camera and 
battery temperature goes down. If you turn on the power without letting the camera 
and battery cool enough, the power may turn off again or you may be unable to 
record movies.
On charging the battery
If you charge a battery that has not been used for a long time, you may be unable to 
charge it to the proper capacity.
This is due to the battery characteristics, and is not a malfunction. Charge the battery 
again.
Warning on copyright
Television programs, films, videotapes, and other materials may be copyrighted. 
Unauthorized recording of such materials may be contrary to the provisions of the 
copyright laws.
No compensation for damaged content or recording failure
Sony cannot compensate for failure to record or loss or damage of recorded content 
due to a malfunction of the camera or recording media, etc.
Cleaning the camera surface
Clean the camera surface with a soft cloth slightly moistened with water, then wipe 
the surface with a dry cloth. To prevent damage to the finish or casing:
– Do not expose the camera to chemical products such as thinner, benzine, alcohol, 
disposable cloths, insect repellent, sunscreen or insecticide.
Maintaining the screen
• Hand cream or moisturizer left on the screen may dissolve its coating. If you get 
any on the screen, wipe it off immediately.
• Wiping forcefully with tissue paper or other materials can damage the coating.
• If fingerprints or debris are stuck to the screen, we recommend that you gently 
remove any debris and then wipe the screen clean with a soft cloth.
Note on disposal/transfer of the camera
To protect personal data, perform the following when disposing of or transferring 
the camera.
• Format the internal memory (page 24), record images up to full capacity of the 
internal memory with the lens covered, and then format the internal memory 
again.
This will make it difficult to recover any of your original data.
• Reset all camera settings by performing [Initialize] 
t [All settings] (page 24).