Toshiba IK-WB01A Benutzerhandbuch
22
Introduction
Installation/Setup
Operation
Others
As shown in the figure below, use a wire clamp to
fix the plug in place
fix the plug in place
・For the wire clamp, use the self-tapping screw supplied with the camera
to hold.
・When the plug is fixed in place, check that it will not become
disconnected by a moderate amount of pulling.
Turning on the Power
The camera has no main power switch or button. To turn the power on,
insert the plug of the power cord into a power outlet.
Turn the power on after you have installed the camera.
insert the plug of the power cord into a power outlet.
Turn the power on after you have installed the camera.
NOTE
●
If you turn the power on without connecting the LAN cable, the network
camera starts in wireless LAN mode.
camera starts in wireless LAN mode.
●
If you connect the LAN cable and then turn the power on, the network camera
starts in ordinary LAN mode.
starts in ordinary LAN mode.
Connecting the Power Cord (Cont.)