Panasonic WV-CLR920A Benutzerhandbuch

-46-

1. Move the cursor to CAMERA RESET. PUSH SW is

highlighted.

2. While holding down 

L and  M, press I for 2

seconds or more. The camera is reset to the factory
settings.

5. Move the cursor to LEVEL and select the illumi-

nance level using 

L or M.

LOW: Colour picture switches to black-and-white at

approximately the minimum illumination.

HIGH: Colour picture switches to black-and-white

at a point brighter than the minimum illumina-
tion.

The factory default setting is HIGH.

6. Move the cursor to DURATION TIME to set the

switching time using 

L or M.

The following switching times are available:

10s--30s--60s--300s
(S)

(L)

1. Move the cursor to BURST (BW).
2. Select ON or OFF using 

L or M.

Default: ON
ON: The burst signal is supplied along with the

black and white composite video signal.

OFF: The burst signal is not output.

Note: Select the appropriate mode for the con-

nected recording device and monitor TV
when setting BW (10-5) and burst signal
(10-6). There may be cases where the
selection will adversely affect synchro-
nization. Select the mode after confirming
that the live picture and playback picture
are properly displayed on the monitor.