Canon MP 190 Pixma Benutzerhandbuch

Troubleshooting

„

The Power and Alarm lamps flash alternately as shown below.

Disconnect the USB cable from the machine, turn the machine off, then unplug the machine from 
the power supply. Plug the machine back in and turn the machine back on.
If the problem is not resolved, contact your Canon Service representative.

E, 2, 2

The FINE Cartridge 
Holder does not move.

Cancel printing, turn off the machine, then remove the protective material 
from the FINE Cartridge Holder or paper jam that is preventing the FINE 
Cartridge Holder from moving.

Be careful not to touch the components inside the machine. The machine 
may not print out properly if you touch it.

E, 2, x
E, 3, x
E, 4, x

An error requiring 
servicing might have 
occurred.

Turn off the machine, and unplug the power plug of the machine from the 
power supply. Then, plug the power plug of the machine back in, and turn 
on the machine again. If the same error occurs, contact your Canon 
Service representative.

The machine is not powered on or the 
LED is in the screen-saver mode.

z

If the Power lamp is off
The machine is not powered on. Connect the power plug and press the ON 
button. The machine will power on and the LED will light.

z

If the Power lamp is lit
The LED may be in the screen-saver mode. On the Operation Panel, press a 
button other than the ON button.