Sony 570WSPL Betriebsanweisung
Chapter 1 Overview
Chapter 1
Overview
27
8
Fitting for optional microphone holder
You can fit an optional CAC-12 Microphone Holder
here. (See page 43.)
here. (See page 43.)
9
Video light connector
A video light with a maximum power consumption of
30 W such as the Anton Bauer Ultralight 2 or
equivalent can be connected.
30 W such as the Anton Bauer Ultralight 2 or
equivalent can be connected.
0
LENS connector (12-pin)
If you use a lens with cable, connect the lens cable.
qa
VIDEO OUT connector (BNC)
This outputs the video signal captured by the
camcorder.
camcorder.
qs
REMOTE connector 2 (10-pin)
Connect the optional RM-M7G Remote Control Unit
to this connector. Set the CAMERA SELECT switch
on the bottom of RM-M7G to 1.
to this connector. Set the CAMERA SELECT switch
on the bottom of RM-M7G to 1.
Notes
• EZ mode cannot be used if the RM-M7G is
connected to the camcorder.
• Be sure to turn off the power of the camcorder before
connecting the RM-M7G.
• Be sure to turn off the power of the camcorder before
disconnecting the equipment connected to this
connector. Otherwise, the camcorder will not work
properly.
connector. Otherwise, the camcorder will not work
properly.
• To control this unit from a CCU (camera control
unit), connect the RM-M7G to the CCU.
Rear section
1
Cassette holder
Power the camcorder and press the EJECT button to
open the lid. Insert the cassette and close the lid by
pressing the indication “PUSH” .
open the lid. Insert the cassette and close the lid by
pressing the indication “PUSH” .
2
GEN LOCK IN (gen lock video input)/VIDEO
IN (video input) connector (BNC)
1
Cassette holder
2
GEN LOCK IN/VIDEO IN connector
a)
3
TC IN connector
4
TC OUT connector
5
S VIDEO OUT connector
6
MONITOR OUT connector
7
AUDIO OUT CH-1/CH-2 connectors
GEN LOCK IN: When synchronizing the camcorder
to an external signal, input a reference video
signal (VBS or BS). (See page 93.)
signal (VBS or BS). (See page 93.)
VIDEO IN: When the optional DSBK-501/501P
Analog Composite Input Board is fitted to the
camcorder, you can input the analog video signals
(VBS) to this connector.
camcorder, you can input the analog video signals
(VBS) to this connector.
a) When the optional DSBK-501/501P is fitted