Westcott 2134 Merkblatt

Light Modifiers

Page 1 of 2 

 

Questions? Please call 800.886.1689 or email 

info@fjwestcott.com

.    

      ©F.J. Westcott Company  

 

 

 

 

 

 

 

 

 

 

Halo Light Modifiers 

Style Series:  2025, 2026, 2034, 2134  
 
 
Description 
The Westcott Halo™ and Halo™ Mono are built on umbrella frames.  There is no need for adapter 
rings, just use the umbrella receptacle on your light.  Easy opening and closing means easy set-up and 
takedown.  Allows for 140 degrees of light spread. 
 
Product Contains 

ƒ [1] 

Halo 

 

 
To mount the standard Halo™ light modifier onto your light, open the hook and loop tape opening and 
partially open the frame.  Place the light inside of the opening of the Halo™ and insert the umbrella 
shaft through the light’s umbrella receptacle.  Position the light anywhere along the umbrella shaft to 
create different lighting effects (see next paragraph for examples).  Tighten the setscrew against the 
shaft.  Do not over tighten!  This could damage the umbrella shaft.  After the Halo™ is securely in 
place, carefully stretch the black back section over the end of the umbrella shaft. Over stretching may 
cause damage to the fabric or frame.  Secure the light modifier by putting the tip of the umbrella shaft 
into the metal cup.  Close the lower hook and loop tape opening around the light stand. 
 
Directional lighting examples: For direct diffusion, position the light facing 
the white diffuser panel.  The light will have a bright center with a softer 
edge.  The distance the light is to the diffuser panel will govern the 
brightness of the center of the light.  Caution: Do not over tighten!  
Overtightening may cause damage to the umbrella shaft.  See the first part of 
the above paragraph to explain placement of the light along the umbrella 
shaft for direct diffusion of light.  
 
Position the elastic collar on the back of the Halo

™ Mono around the front 

portion of he mono light.  With the mono light standard reflector in place, the 
flash tube and reflector should be inside the Halo

™ and the controls should 

be outside.  Finish mounting the Halo

™ Mono by closing the hook and loop 

tape opening creating a snug fit.