Panasonic NV-DS65 Benutzerhandbuch

Power Supply

ª Using the AC Adaptor
1

Connect the DC Input Lead to the [DC/C.C. IN]
Socket on the Movie Camera.

Connect the DC Input Lead to the AC Adaptor.

Connect the AC Mains Lead to the AC Adaptor
and the AC mains socket.

≥The AC Mains Lead’s outlet plug cannot be pushed fully

into the AC Adaptor socket. A gap will remain as shown

≥Before connecting or disconnecting the power supply, set

the [VCR/OFF/CAMERA/M-CARD] Switch on the Movie
Camera to [OFF] and make sure that the [POWER] Lamp is
not lit.

ª Using the Battery

Before use, fully charge the Battery.

Attach the Battery to AC Adaptor and charge it.

≥Since the Battery will not be charged when the DC Input

Lead is connected to the AC Adaptor, disconnect them.

≥The [POWER] Lamp and [CHARGE] Lamp lights up, and

charging starts.

≥When the [CHARGE] Lamp goes off, charging is

completed.

Attach the charged Battery to the Movie Camera.

To Remove the Battery

Set the [VCR/OFF/CAMERA/M-CARD] Switch

to [OFF], and

while pressing the [BATTERY RELEASE] Lever

, slide the

Battery to remove it.
≥When attaching or removing Battery, set the [VCR/OFF/

CAMERA/M-CARD] Switch to [OFF] and make sure the
[POWER] Lamp is not lit.

ª Using the Car Battery Charger

If you use the Car Battery Charger (VW-KBD2E; optional), you
can supply power to the Movie Camera and charge the battery
inside your car. For further information, refer to the instruction
manual of the Car Battery Charger.
≥Be sure to start the car engine before you connect the Car

Adaptor Cord, otherwise the fuse may blow.

≥For other notes concerning this item, see page 46.

M-CARD

CAMERA

OFF

VCR

BATTERY
RELEASE

EG-ENG.book 10 ページ２００３年１月６日　月曜日　午後３時４３分