Panasonic NV-DS65 Benutzerhandbuch

Watch for Condensation even before the 
Condensation Indication is displayed.
≥Because condensation takes place gradually, 

the Condensation Indication may not be 
displayed during the first 10 to 15 minutes of 
condensation formation inside the Movie 
Camera.

≥In extremely cold places, condensation may 

freeze and form frost. In this case, the frost melts 
first, thus forming condensation, and then it 
takes another 2 to 3 hours to eliminate the 
condensation.

When the Lens is Fogged:
Set the [VCR/OFF/CAMERA/M-CARD] Switch to 
[OFF] and leave the Movie Camera in this 
condition for about 1 hour. When the lens 
temperature becomes close to the ambient 
temperature, the fog disappears naturally.

ª Video Head Clogging and Care

If the heads (the parts that make contact with 
tape) are dirty, mosaic-pattern noise may appear 
on the playback image, or the screen as a whole 
becomes black. If the heads are extremely dirty, 
recording performance deteriorates, and, in the 
worst case, the Movie Camera cannot record at 
all.
Causes of Dirty Heads
≥Large quantity of dust in the air
≥High-temperature and high-humidity 

environment

≥Damaged tape
≥Long operating hours
Using Mini-DV Format Digital Video Head 
Cleaner

1] Button, and 

∫] Button. (Do not rewind the 

Notes:
≥Do not rewind every time you use the Head 

Cleaner. Rewind only when the tape reaches the 
end, and then use it again from the beginning in 
the same manner as before.

≥If the heads become dirty soon after cleaning, 

the tape may be damaged. In this case, 
immediately stop using that Cassette.

≥Do not clean the heads excessively. (Excessive 

cleaning may cause excessive wear of the 
heads. If the heads are worn, images cannot be 
played back even after the heads are cleaned.)

≥If the dirty heads cannot be cleaned with the 

Head Cleaner, the Movie Camera needs to be 
cleaned at a service centre. Please consult a 
dealer.

≥Video Head Cleaners can be purchased from 

service centres.

≥Head cleaning due to dirty heads is not 

considered a malfunction of the product. It is not 
covered by the warranty.

Periodical Check-up
To maintain the highest image quality, we 
recommend replacement of worn parts, such as 
heads, etc., after approximately 1000 hours of 
use. (This, however, depends on operating 
conditions, such as temperature, humidity, dust, 
etc.)

ª Optimal Use of the Battery

Battery Characteristics
This Battery is a rechargeable lithium ion battery. 
Its ability to generate power is based upon the 
chemical reaction that takes place inside it. This 
reaction is susceptible to the surrounding 
temperature and humidity, and, if the temperature 
is too high or too low, the operating time of the 
Battery becomes shorter. If the Battery is used in 
an extremely cold environment, the Battery may 
operate only for about 5 minutes. If the Battery 
becomes extremely hot, a protective function may 
operate, and the Battery may become unusable 
for a while.
Be Sure to Detach the Battery after Use
Be sure to detach the Battery from the Movie 
Camera. (If it is left attached to the Movie Camera, 
a minute amount of current is consumed even 
when the Movie Camera power is off.) If the 
Battery is left attached to the Movie Camera for a 
long time, over discharge takes place. The Battery 
may become unusable after it is charged.
Disposing of an Unusable Battery
≥The Battery has a limited life.

EG-ENG.book  52 ページ  ２００３年１月６日　月曜日　午後３時４３分