Panasonic NV-GS27EB Benutzerhandbuch
Before using
8
LSQT1006
Power supply
ª
Charging the battery
When this product is purchased, the battery is not
charged. Charge the battery before using this
product.
≥Battery charging time (
charged. Charge the battery before using this
product.
≥Battery charging time (
-9-
)
≥We recommend using Panasonic batteries.
≥If you use other batteries, we cannot guarantee
≥If you use other batteries, we cannot guarantee
the quality of this product.
≥If the DC input lead is connected to the AC
adaptor, then the battery will not get charged.
Remove the DC input lead from the AC adaptor.
Remove the DC input lead from the AC adaptor.
1
Connect the AC mains lead to the AC
adaptor and the AC mains socket.
adaptor and the AC mains socket.
2
Put the battery on the battery mount by
aligning the mark, and then securely plug it
in.
aligning the mark, and then securely plug it
in.
ª
Charging lamp
Lights up: Charging
Goes off: Charging completed
Flashing: The battery is over discharged
Goes off: Charging completed
Flashing: The battery is over discharged
(discharged excessively). In a while,
the lamp will light up and normal
charging will start.
When the battery temperature is
excessively high or low, the
[CHARGE] lamp flashes and the
charging time will be longer than
normal.
the lamp will light up and normal
charging will start.
When the battery temperature is
excessively high or low, the
[CHARGE] lamp flashes and the
charging time will be longer than
normal.
ª
Connecting to the AC outlet
1
Connect the AC mains lead to the AC
adaptor and the AC mains socket.
adaptor and the AC mains socket.
2
Connect the DC input lead to the AC
adaptor.
adaptor.
3
Connect the DC input lead to this product.
≥The output plug of the AC mains lead is not
≥The output plug of the AC mains lead is not
completely connected to the AC adaptor
socket. As shown in
socket. As shown in
1, there is a gap.
≥Do not use the power cord for other
equipment since the power cord is exclusively
designed for the movie camera. Or do not use
the power cord of other equipment for the
movie camera.
designed for the movie camera. Or do not use
the power cord of other equipment for the
movie camera.
ª
Fitting the battery
Push the battery against the battery holder and
slide it until it clicks.
slide it until it clicks.
ª
Removing the battery
While sliding the [BATTERY RELEASE] lever,
slide the battery to remove it.
slide the battery to remove it.
≥Hold the battery with your hand so it does not
fall.
≥Before removing the battery, be sure to set the
[OFF/ON] switch to [OFF].
1
BATTERY
RELEASE
LSQT1006ENG.book 8 ページ ２００５年１２月９日 金曜日 午前１１時１７分