Panasonic VDR-M50PP Benutzerhandbuch

Seite von 174
158
Troubleshooting
Check to see the following before asking for a repair. If the suggested solution still cannot restore the DVD 
Video Camera to normal, do not attempt to repair it yourself, but consult your dealer. 
Power supplies
Symptom
Cause and Correction
Reference 
page
Battery pack cannot be 
charged.
*
If the battery pack does 
not charge after you try 
the four procedures 
shown on the right, it 
may be dead: 
Purchase a new 
battery pack.
Is the ambient temperature too low or too high?
Charge the battery pack at 50-86ºF (10-30ºC).
23
Is the battery pack abnormally hot?
Remove the battery pack, leave it for a while to cool down, then 
charge it.
Is the DC cord connected to AC adaptor? Unplug it.
Has the battery pack been unused for a long time?
Remove the battery pack, and then reattach it.
Battery pack weakens 
fast.
Are you using the DVD Video Camera where the temperature is very 
low?
The DVD Video Camera can normally be used for 40-60 minutes 
with a fully charged CGA-DU14A battery pack, but this time will be 
shorter at low temperatures. Keep extra batteries on hand.
43
Battery pack may be dead.
The performance of battery pack will deteriorate if it is used for an 
extended period of time or frequently: Purchase a new battery pack.
44
The CHARGE indicator 
on AC adaptor is blinking.
Is the ambient temperature too low or too high?
Charge the battery pack in environment where the temperature is 
50-86°F (10-30°). 
The battery pack has possibly discharged excessively. Continue 
charging: After a while, the battery pack will be charged to the 
specified voltage, and the CHARGE indicator will light. Then the 
battery charge will be completed normally.
43
Power turns off 
immediately after being 
turned on.
Is battery pack charged?
Charge it.
23
When power is turned 
on, the LCD screen will 
turn on and off.
Power goes off  
unexpectedly.
Is Power Save set to “On”? 
If the powered DVD Video Camera is left for as long as 5 minutes 
without recording or playback with “Power Save: On” specified, it will 
automatically turn off to save battery power. To restart recording in 
this case, set the power switch to “OFF” and then set it to “
”. You 
can also specify “Power Save: Off” to stop automatic power off.
92
Power cannot be turned 
off.
Detach the battery pack or AC adaptor once, and then press the 
RESET button of DVD Video Camera: Reattach a power supply to 
DVD Video Camera before turning it on again.