Panasonic VQT2H52 Benutzerhandbuch

Seite von 152
19
VQT2H52
Preparation
Setup
1
Power supply
∫ About batteries that you can use with this unit
The battery that can be used with this unit is VW-VBG070/VW-VBG130/VW-VBG260/VW-VBG6.
≥ This unit has a function to distinguish the batteries that can be used, and the batteries 
(VW-VBG070/VW-VBG130/VW-VBG260/VW-VBG6) are compatible with this function. (The 
batteries that are not compatible to this function cannot be used.)
≥ To use the VW-VBG260/VW-VBG6 for this unit, the battery pack holder kit VW-VH04 (optional) 
is required.
Important:
If the DC cable is connected to the AC adaptor, then the battery will not charge. Remove the DC 
cable from the AC adaptor.
1
Connect the AC cable to the AC adaptor and the AC outlet.
2
Insert the battery into the AC adaptor by aligning the arrows.
It has been found that counterfeit battery packs which look very similar to the genuine 
product are made available to purchase in some markets. Some of these battery packs are 
not adequately protected with internal protection to meet the requirements of appropriate 
safety standards. There is a possibility that these battery packs may lead to fire or explosion. 
Please be advised that we are not liable for any accident or failure occurring as a result of use 
of a counterfeit battery pack. To ensure that safe products are used we would recommend 
that a genuine Panasonic battery pack is used.
Charging the battery
When this unit is purchased, the battery is not charged. Charge the battery before using this 
unit.
Charging lamp [CHARGE]
A
Lights up:
Charging (Battery charging time: 
l 21)
Goes off:
Charging completed
Flashing:
Make sure that the terminals of the battery or the 
AC adaptor are not exposed to dirt, foreign 
objects or dust, then reconnect them properly. 
(
l 135)
HDCSD10_TM10_TM15P-VQT2H52_eng.book  19 ページ  2009年7月6日 月曜日 午後1時46分