Panasonic BB-HCM547 Merkblatt

© 2008 Panasonic Communications Co., Ltd. All Rights Reserved.
PQQX16398ZA   KK0608CM0

This manual is written for both the BB-HCM527 (Indoor Use Only) and the 
BB-HCM547(Outdoor Ready). Available features and operations vary 
slightly depending on the model. You can confirm the model no. of your 
camera by checking the model no. printed on the front of the camera.
Model number suffix “A” is omitted from the following model numbers 
shown in this document, unless necessary. BB-HCM527A, BB-HCM547A
All documentation can be found on the included CD-ROM.

• Important Information (PDF format; printed version also included)

This document. Provides general information and safety instructions for 
using the camera.

• Installation Guide (PDF format; printed version also included)

For BB-HCM527: Describes how to physically connect the camera to 
the power supply and network, as well how to mount or place the 
camera for regular use.
For BB-HCM547: Describes how to connect the camera to the power 
supply and network physically.

• Mounting Guide (PDF format; printed version also included)

For BB-HCM547: Describes how to mount or place the camera for 
regular use.

• Setup Guide (PDF format; printed version also included)

Describes how to set up the camera so that it can be accessed using a 
PC.

• Operating Instructions (HTML format)

Explains how to operate, program, and maintain the camera.

• Troubleshooting Guide (HTML format)

Provides solutions for problems you may have when using the camera.

• Stand-alone SD Memory Card Recording Guide (PDF format; printed 

version also included)
Describes how to record images to an SD memory card without using a 
PC.

• The Network Camera is referred to as “the camera” in this document.
• The Setup CD-ROM is referred to as “the CD-ROM” in this document.
• The term “SD memory card” is used in this document to refer to SD 

memory cards and SDHC memory cards.

When using this unit, basic safety precautions should always be followed 
to reduce the risk of fire, electric shock, or personal injury.
Note:

• References to the AC adaptor and the AC cord apply when using the 

optional BB-HCA3A AC Adaptor.

1.

Read and understand all instructions.

2.

Keep these instructions.

3.

Heed all warnings.

4.

Follow all instructions.

5.

Attach the Safety Wire to the camera to prevent it from dropping.

6.

After taking away the sand or the dust on the lens cover, wipe the lens 
cover with a dry cloth.

7.

Do not block any ventilation openings. Install in accordance with 
instructions.

8.

Do not install near any heat sources such as radiators, heat registers, 
stoves, or other devices (including amplifiers) that produce heat.

9.

Protect the AC adaptor cord and the AC cord from being walked on or 
pinched particularly at plugs, convenience receptacles, and the point 
where they exit from the unit.

10. The AC adaptor is used as the main disconnect device. Ensure that 

the AC outlet is installed near the product and is easily accessible.

11. Only use attachments/accessories such as stand specified by the 

manufacturer.

12. Do not touch the unit, the LAN cable, the AC adaptor, the AC adaptor 

cord, or the AC cord during lightning storms.

13. Unplug the unit from power supply when unused for long periods of 

time.

14. Refer all servicing to qualified service personnel. Servicing is required 

when the unit has been damaged in any way, such as when the AC 
adaptor, the AC adaptor cord, or the AC cord is damaged, the unit 
does not operate normally, or has been dropped.

15. Prolonged exposure to direct sunlight or halogen light may damage 

the image sensor.

16. For BB-HCM527: The camera is intended for indoor use only.

For BB-HCM547: The camera features a splash-resistant body, but it 
is not waterproof.

17. Keep the SD memory card (customer-provided) out of reach of 

children to prevent swallowing.

18. Unplug this unit from power supply if it emits smoke, an abnormal 

smell or makes unusual noise. These conditions can cause fire or 
electric shock. Confirm that smoke has stopped and contact an 
authorized service center.

19. The AC adaptor, the AC adaptor cord, and the AC cord are not splash 

resistant, and are intended for indoor use only.

20. When installing cables through the ground, do not connect cables 

under the ground. Install cables through a conduit to protect them from 
water.

This equipment has been tested and found to comply with the limits for a Class 
B digital device, pursuant to Part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one or 
more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to 

which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject 
to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device 
must accept any interference received, including interference that may 
cause undesired operation.
Environment:
For BB-HCM527: Do not install the camera where the temperature is less 
than +0 °C (+32 °F) or greater than +40 °C (+104 °F). Allow 10 cm 
(4 inches) clearance around the unit for proper ventilation. Avoid excessive 
smoke, dust, mechanical vibration, shock, or direct sunlight.
For BB-HCM547: Do not install the camera where the temperature is less 
than -20 °C (-4 °F) or greater than +50 °C (+122 °F). Allow 10 cm (4 inches) 
clearance around the unit for proper ventilation. Avoid excessive smoke, 
dust, mechanical vibration, shock, or direct sunlight.
Routine care:
Wipe the unit with a soft cloth. Do not use benzine, thinner, or any abrasive 
powder.
When you leave the unit unused for a long period of time, disconnect the 
LAN cable (when using PoE) from the camera, or disconnect the AC 
adaptor from the outlet (when using the AC adaptor).
If you have any problems:
Consult an authorized Panasonic Factory Service Center.
CAUTION:
Any changes or modifications not expressly approved by the party responsible 
for compliance could void the user’s authority to operate this device.

Please read this document before using the product, and save this document for future 
reference. 
Panasonic Network Camera Website:
http://panasonic.co.jp/pcc/products/en/netwkcam/regionlinks/index.html