Panasonic AJ-SPX800E Benutzerhandbuch

Plug the AJ-B75 DC OUT connector into the camera-
recorder’s external DC input socket. 

Turn the AC adapter power ON. 

Turn the camera-recorder power switch ON. 

z When both the battery pack and AC adapter are

connected, power is supplied from the AC adapter. The
battery can be removed or mounted while using the AC
adapter. 

z When using the AC adapter, make sure you turn ON the

AC adapter power before turning ON the camera-
recorder’s power switch. If this sequence is reversed, the
camera-recorder may malfunction due to slow rising of
the AC adapter output voltage. 

z When connecting a battery to the DC IN socket, select

the battery type listed under EXT DC IN SELECT. Select
EXT DC IN SELECT from the <BATTERY/P2CARD>
screen on the MAIN OPERATION page. In this case,
however, the % display is disabled, even when using a
digital battery. 

Please refer to the viewfinder instruction manual. 
Note: A slide rail is required to mount any viewfinder other than
models AJ-VF15B or AJ-VF20WB.

z If you need to buy a slide rail, please contact the store where

you purchased the camera-recorder and tell them that the
slide rail is a “repair part”.

Slide rail (VFC3995)
Screws (XBS3+8VZ)

Undo the upper two screws for AJ-VF15 or AJ-VF20W, and
remove the mounting unit.
Leave the screws attached to the mounting unit.

Mount the slide rail, then tighten the two screws.

AC Adapter
z AJ-B75 (Optional) 

When using an external power supply other than the AC
adapter AJ-B75, check the DC IN socket pin information to
ensure correct polarity. If a +12V power supply is accidentally
connected to the GND terminal, this could cause a fire or
personal injury.

1

2

3

4

1

GND

2, 3

—

4

+12V