Panasonic AJSPC700P Benutzerhandbuch

27

When two or more P2 card slots contain cards, this function
allows the target P2 card to be switched in order. Even when
the free space of a P2 card is used up, this function
continues recording while erasing existing data. 
To use this function, the menu option LOOP REC MODE
must be set to “ON” The option LOOP REC MODE can be
found in the <REC FUNCTION> screen on the SYSTEM
SETTING page.

z When the loop recording capability is used, each P2 card

must have at least one minute of free space.

z During loop recording, the P2 CARD ACCESS LEDs for all

target P2 cards illuminate in orange. Note that if any of the
target P2 card is removed, loop recording stops.

z When the menu option LOOP REC MODE is set to ON,

the viewfinder and display window both show “LOOP”.
However, when only one card is inserted, or when each
card has less than one minute of free space, the loop
recording capability does not work, even if the option
LOOP REC MODE is set to ON. If this is the case, the
indication “LOOP” flashes in the viewfinder and on the
display window.

z When the menu option LOOP REC MODE is set to ON,

the P2 card remaining free space indicates the minimum
guaranteed recording time.
The minimum guaranteed recording time refers to the
sum, at the time loop recording is stopped, of the
remaining free space of available P2 cards, except for the
card with the largest remaining free space.
Example: If three P2 cards are available, with remaining

space of eight minutes, five minutes and two
minutes respectively, then the minimum
guaranteed recording time is seven minutes.

z During recording of IEEE1394 input, LOOP REC is not

available.

You can terminate the loop recording mode by either:
z Turning off the POWER switch of the AJ-SPC700P; or
z Setting the menu option LOOP REC MODE to “OFF”. 

When recording is paused, pressing the RET button
automatically locates the last two seconds of video just
recorded, and the viewfinder provides video playback. 
After playback, the video camera-recorder is again ready to
start recording.
The picture location/playback duration can be increased to
up to 10 seconds by continuously pressing the RET button.
For short clips, however, when the start of a clip is located,
continuously pressing the RET button does not play back
any clips before that clip.
The function of the RET button may be assigned to a desired
user button by using one of the menu options USER MAIN
SW, USER1 SW or USER2 SW. These options can be found
in the <USER SW> screen on the CAM OPERATION page.
When recording is paused, pressing the PLAY/PAUSE
button plays back the last recorded clip, from the beginning.
After completion of playback, the camera-recorder enters the
stopped state.

When the VIDEO OUT OUTPUT SEL switch on the side
panel is positioned at [MEM], the video for REC REVIEW is
output from the video output connectors (VIDEO OUT
connector), and also to the viewfinder.
Note that when a backup device is connected to back up the
video the pictures for REC REVIEW are backed up. 

B

A

C

B

C

D

The data is recorded in the free space of each P2 card (in order 
of A 

 B  C). When the free space is used up, the content on 

A is erased to perform a new recording on D. 

#,52%2 'PINKUJDQQMࡍ࡯ࠫ㧞㧜㧜㧢ᐕ㧡᦬㧝㧝ᣣޓᧁᦐᣣޓඦ೨㧥ᤨ㧠㧡ಽ