Panasonic AJSPC700P Benutzerhandbuch

Chapter 5 Preparation

(continued)

5-4-3 When Using Audio Devices

Connect the audio device to the AUDIO IN jack with the
XLR cable.

Set the AUDIO IN switch to [REAR] for the channel to
which the XLR cable is connected.

Set the LINE/MIC/+48V selector switch on the rear
panel to [LINE].

5-5 Connection between the USB

2.0 port of the AJ-SPC700P and
a PC

By connecting the AJ-SPC700P with an external PC using
USB 2.0, the P2 card connected to the AJ-SPC700P can be
used as a mass storage device.

Procedures for establishing a connection with a PC

Connect the USB cable to the USB 2.0 port.

<Notes>

z The USB 2.0 cable is not included with AJ-SPC700P.

Please use a commercially available USB 2.0 cable
(shield with a ferrite core).

z The length of the USB cable shall be not exceed 3

meters. Using a USB cable whose length is greater
than 3 meters might result in erroneous operations.

Open the <SYSTEM MODE> screen on the SYSTEM
SETTING page from the menu, and set USB to ON.

<Note>

The function of the menu option USB may be assigned
to a desired user button by using any one of the menu
options USER MAIN SW, USER1 SW or USER2 SW.
These options can be found in the USER SW screen,
which is accessible from the CAM OPERATION page.

LINE/MIC/+48V
Selector Switch

AUDIO IN Jack

AUDIO IN
Switch

USB
2.0 port

6<67(002'(!

5(&6,*1$/&$0
$63(&7
5(&02'(0
6(783
5(&7$//<5('
$&&(66/('21

86%21

When you establish the USB connection for the first time,
install the accessory P2 software for AJ-SPC700P on the
PC. Refer to the Installation Manual for the details.

#,52%2 'PINKUJDQQMࡍ࡯ࠫ㧞㧜㧜㧢ᐕ㧡᦬㧝㧝ᣣޓᧁᦐᣣޓඦ೨㧥ᤨ㧠㧡ಽ