Panasonic NV-RZ9EN Benutzerhandbuch

Seite von 74
-144-
ENGLISH
Before Requesting Service
(Problems & Solutions)
Power Supply
P1:
The Movie Camera does not turn on.
S1:
Is the Battery or the AC Adaptor connected correctly?
Confirm the connection. (
l 18, 20)
P2:
The Movie Camera has turned off automatically.
S2:
If you leave the Movie Camera in the Recording Pause
Mode for more than 6 minutes, it automatically
switches off to protect the tape and to conserve battery
power. To resume recording from this condition, set the
[CAMERA/OFF/VCR] Switch to [OFF] and then to
[CAMERA] again. (
l 54)
P3:
The Movie Camera quickly turns off.
S3-1: Is the Battery discharged? When the Remaining
Battery Operation Time Indication shows “0:00” or the
[
6] Indication is flashing, the Battery is discharged.
Charge the Battery or attach a fully charged Battery.
(
l 20)
S3-2: Has condensation formed? If the Movie Camera is
brought from a cold to a warm place, condensation
may form inside. In this case, the Movie Camera
automatically switches off and no operations can be
performed except taking out the cassette. Wait until the
Condensation Indication disappears (approximately
2–3 hours). (
l 128)
Cassette
P1:
The Remaining Tape Time Indication is not correct.
S1:
Is the tape length of the inserted cassette correctly
selected? Select the correct tape length. (
l 42)
P2:
The Movie Camera and cassettes underwent
security X-ray inspection at an airport. Does this
affect the cassettes?
S2:
No, this has no negative influence on the Movie
Camera or the cassettes.
P3:
When playing back a cassette that was stored for
some time, the picture is distorted.
S3:
The cassette was stored in an unsuitable place (dusty,
humid, hot, etc.) or near strongly magnetized objects or
equipment. Unfortunately, there is no remedy. Always
store the cassettes correctly. (
l 126)
Recording
P1:
No picture appears in Finder. (NV-VZ9/VZ10 only)
S1:
LCD Monitor is open (Except when recording with LCD
Monitor facing forward).
Securely close LCD Monitor. (
l 26)
P2:
Picture on LCD Monitor is not clear.
(NV-VZ9/VZ10 only)
S2:
Picture quality is not properly adjusted.
Adjust picture quality. (
l 38)
 !"#
!"#$%&

mN
!"#$%&'(
pN
!"#$%&'()*+$,-."/#$0
l=NU  OM
mO
!"#$%&
pO
!"#$%&'(")*+,-.S !"#
!"#$%&'"()*+,-./01234
!"#$x`^jbo^LlccLs`oz !" L  L 
  !"x l c c z  !"#$%&'
x`^jbo^z
!"# l=RQ
mP
!"#$%&'(
pPJN
  !"#$%&'()*+,-./.0
MMMx6z !"#$%&'()*+,-&
!"#$ % &l=OM
pPJO
  !"#$%&'()*+,-./012340
!"#$%&'()*+,-./ 0123%
!"#$%&'()*+",-./0123
!"#$%&'()*+,- OJP  
l=NOU
 
mN
!"#$%&'()
pN
!"#$%&'()*+,-./"# !+(
!"l=QO
mO
!" #$!%&'(  !"#$%&
!"#
pO
!"#$!"%&'()"*+
mP
!"#$ !%&'()*+&,*-./0
pP
!"#$%&'()*+,- !"#$"%
! !"#$%&'()*+,-./0
!"#$%&'()*+!l=NOS

mN
!"#$%!& ! ksJswVLswNM
pN
!"#$%&'()*+ !"#$%&'(
!"#$%&'(
!"#$%&'()*+,-l=OS
mO
!"#$%&'()*+, ! ksJswVL
swNM
pO
!"#$%&'(
!"#$%l=PU