Panasonic NV-GS60GN Benutzerhandbuch

Seite von 48
Before using
12
LSQT1174
Quick start
When quick start is on the battery power is still
being consumed, even when the LCD monitor 
and the viewfinder are closed.
The camera will resume recording/pause mode 
about 1.7 seconds after the LCD monitor or the 
viewfinder is reopened.
≥Please note in quick start mode approximately 
half the pause recording power is being 
consumed. Using quick start mode will reduce 
the battery recording/playback time.
≥This is only activated in the following cases.
≥While using the battery
A tape is inserted, while the Tape Recording 
Mode is set.
≥While using the AC adaptor
Quick Start can be used even if a tape is not 
inserted.
Set to Tape Recording Mode.
1
Set [SETUP] >> [QUICK START] >> [ON]. 
(
-16-
)
2
While the [OFF/ON] switch is still set to 
[ON], close the LCD monitor and retract the 
viewfinder.
≥The status indicator lights green and the unit 
goes into quick start standby mode.
≥The movie camera will not go into quick start 
standby unless the LCD monitor is closed and 
the viewfinder is retracted.
3
Open the LCD monitor or extend the 
viewfinder.
≥The status indicator lights red and the camera 
is put into recording pause approx. 
1.7 seconds after it is turned on.
ª
To cancel Quick Start
1
Set [SETUP] >> [QUICK START] >> [OFF]. 
(
-16-
)
≥If the [OFF/ON] switch is set to [OFF] while the 
unit is in quick start standby, the power turns off.
≥If the standby continues for approx. 30 minutes, 
then the status indicator will go off and the 
camera will be completely turned off.
≥In the following cases, quick start is cancelled 
and the power turns off.
≥When the Mode dial is moved.
≥When the battery or AC adaptor is removed.
≥When the tape is removed while using the 
battery in Tape Recording Mode.
≥When the camera is quick-started with the white 
balance on automatic, it may take some time 
until the white balance is adjusted if the scene 
being recorded has a light source different from 
the scene last recorded. (When the colour night 
view function is used, however, the white 
balance of the scene last recorded is retained.) 
≥If the power is turned on in quick start standby, 
the zoom magnification becomes 5
k and the 
picture size may differ from what it was before 
quick start standby.
≥If [POWER SAVE] (
-36-
) is set to [5 MINUTES] 
and the unit automatically goes into quick start 
standby mode, set the [OFF/ON] switch to 
[OFF], then to [ON] again. Also, close the LCD 
monitor and retract the viewfinder and then 
open the LCD monitor or extend the viewfinder 
again.
OFF
ON
OFF
ON
OFF
ON
LSQT1174ENG.book  12 ページ  2007年1月29日 月曜日 午後1時28分