Panasonic AJ-HPX3100G Benutzerhandbuch
110
Preparation: Power Supply
1
Connect the external DC power supply to the
DC IN socket on the unit.
DC IN socket on the unit.
2
Turn “ON” the power switch of the external DC
power supply.
power supply.
(If the power switch is available on the external DC
power supply)
power supply)
3
Turn ON the POWER switch on the unit.
Notes
z
If both the battery pack and the external DC power
supply are connected, the electric power is supplied
from the external DC power supply. While the external
DC power supply is used, the battery can be mounted
and removed on/from the unit.
supply are connected, the electric power is supplied
from the external DC power supply. While the external
DC power supply is used, the battery can be mounted
and removed on/from the unit.
z
When the external DC power supply is used, ensure
that the power switch of the external DC power supply
is turned on first and then the POWER switch on the
unit is turned on. In the case of the reverse operation, a
malfunction may occur on the unit since the output
voltage of the external DC power supply is raised
slowly.
that the power switch of the external DC power supply
is turned on first and then the POWER switch on the
unit is turned on. In the case of the reverse operation, a
malfunction may occur on the unit since the output
voltage of the external DC power supply is raised
slowly.
z
When using a power supply from the DC IN socket, the
light circuitry will not operate. The light circuitry can
only be operated when powered from an Anton/Bauer
battery plate.
light circuitry will not operate. The light circuitry can
only be operated when powered from an Anton/Bauer
battery plate.
Use of the external DC power supply
DC IN Socket
External DC
power supply
power supply
Inrush current is generated when the power of the
unit is turned on. Insufficient power supply when
turning on the power may cause a malfunction. We
recommend using an external DC power supply with
double the capacity of the total power consumption
of the unit and any other connected device that is
turned by interlocking with the power on of the unit
(the viewfinder). For the DC cord, please use a dual-
core, balanced type shielded wire of at least AWG18
unit is turned on. Insufficient power supply when
turning on the power may cause a malfunction. We
recommend using an external DC power supply with
double the capacity of the total power consumption
of the unit and any other connected device that is
turned by interlocking with the power on of the unit
(the viewfinder). For the DC cord, please use a dual-
core, balanced type shielded wire of at least AWG18
gauge (nominal cross section 0.824 mm
2
).
Confirm the pin arrangements of the DC output
connector of the external DC power supply and the
DC IN socket on the unit, and connect the proper
polarities to each other.
If the 12 V power supply is connected to the GND
connector in error, it may cause a fire or failure of
the unit.
connector of the external DC power supply and the
DC IN socket on the unit, and connect the proper
polarities to each other.
If the 12 V power supply is connected to the GND
connector in error, it may cause a fire or failure of
the unit.
1
2
3
4
Pin No.
Signal
1
GND
2, 3
—
4
+12V
CASE
FRAME GND
DC IN Socket
AJ-HPX3100G(VQT3A79)_E.book 110 ページ ２０１０年９月１７日 金曜日 午後９時２１分