Panasonic AJ-HDX900 Benutzerhandbuch
33
4
When there is no time to adjust the white balance
Set the WHITE BAL switch to PRST. The white balance for
the filter is achieved in accordance with the setting position
of the FILTER control (outer).
the filter is achieved in accordance with the setting position
of the FILTER control (outer).
When the white balance cannot be adjusted
automatically
automatically
When the white balance adjustment was not completed
correctly, one of the following error messages will appear on
the viewfinder screen. When an error message is displayed,
take the recommended action, and try adjusting the white
balance again. If the error message persists even after
repeated attempts, the inside of the unit must be inspected.
For details, contact your dealer.
correctly, one of the following error messages will appear on
the viewfinder screen. When an error message is displayed,
take the recommended action, and try adjusting the white
balance again. If the error message persists even after
repeated attempts, the inside of the unit must be inspected.
For details, contact your dealer.
Messages relating to white balance adjustment
Error
message
Meaning
Recommended action
Select a suitable filter.
COLOR TEMP.
HIGH
HIGH
Color temperature is too
high.
high.
Select a suitable filter.
COLOR TEMP.
LOW
LOW
Color temperature is too
low.
low.
Increase the amount of light
or increase the gain.
or increase the gain.
LOW LIGHT
There is not enough light.
Reduce the amount of light
or reduce the gain.
or reduce the gain.
LEVEL OVER
There is too much light.
Check the CC filter selector
control.
control.
CHECK FILTER
The setting position of the
CC filter selector control is
not correct.
CC filter selector control is
not correct.
The shooting conditions
may be unstable. If flicker
occurs, engage the shutter
and shoot again under
stable conditions.
may be unstable. If flicker
occurs, engage the shutter
and shoot again under
stable conditions.
TIME OVER
AWB was not completed
within the allotted time.
within the allotted time.
White balance memories
The values stored in the memories are retained even after
the unit’s power has been turned off until the white balance is
next adjusted. There are two sets of white balance
memories, A and B.
When ON has been selected (initial setting) as the setting for
the FILTER INH item on the <WHITE BALANCE MODE>
screen opened from the OPERATION page by performing
menu operations, the number of memories is limited to one
in A and one in B. In this case, the memory contents are not
coupled with the CC filter.
When FILTER INH is set to OFF, the adjustment values for
each CC filter can be automatically saved in the memories
corresponding to the WHITE BAL switch settings (A or B).
This unit contains four filters so that a total of 8 (4a2)
adjustment values are saved.
When the S. GAIN function operates, the AWB switch is not
activated and is the PRST value of the WHITE BAL switch.
the unit’s power has been turned off until the white balance is
next adjusted. There are two sets of white balance
memories, A and B.
When ON has been selected (initial setting) as the setting for
the FILTER INH item on the <WHITE BALANCE MODE>
screen opened from the OPERATION page by performing
menu operations, the number of memories is limited to one
in A and one in B. In this case, the memory contents are not
coupled with the CC filter.
When FILTER INH is set to OFF, the adjustment values for
each CC filter can be automatically saved in the memories
corresponding to the WHITE BAL switch settings (A or B).
This unit contains four filters so that a total of 8 (4a2)
adjustment values are saved.
When the S. GAIN function operates, the AWB switch is not
activated and is the PRST value of the WHITE BAL switch.
Chapter 4 Adjustments and settings for recording
(continued)
01.AJ-HDX900_P_E(VQT0X86)_E 06.6.22 12:52 PM ページ33