Panasonic AJ-HDX900 Benutzerhandbuch
36
4-3-2 Setting the shutter mode and speed
The shutter speeds used in the shutter mode are set by
switching the SHUTTER switch.
The shutter speeds in the SYNCHRO SCAN mode can
easily be changed using the SYNCHRO SCAN (+ and –)
buttons on the side panel.
Open the <SHUTTER SPEED> screen and <SHUTTER
SELECT> screen from the OPERATION page by performing
menu operations. It is now possible to restrict the shutter
speed selection range to the required range beforehand
and/or select whether to use the SYNCHRO SCAN mode
and SUPER V mode beforehand.
Once selected, the shutter speed is retained even after the
unit’s power has been turned off.
switching the SHUTTER switch.
The shutter speeds in the SYNCHRO SCAN mode can
easily be changed using the SYNCHRO SCAN (+ and –)
buttons on the side panel.
Open the <SHUTTER SPEED> screen and <SHUTTER
SELECT> screen from the OPERATION page by performing
menu operations. It is now possible to restrict the shutter
speed selection range to the required range beforehand
and/or select whether to use the SYNCHRO SCAN mode
and SUPER V mode beforehand.
Once selected, the shutter speed is retained even after the
unit’s power has been turned off.
#< SHUTTER SPEED >
SYNCHRO SCAN :ON
POSITION1 :ON
POSITION2 :ON
POSITION3 :ON
POSITION4 :ON
POSITION5 :ON
POSITION6 :ON
POSITION1 :ON
POSITION2 :ON
POSITION3 :ON
POSITION4 :ON
POSITION5 :ON
POSITION6 :ON
#< SHUTTER SELECT >
POSITION1 SEL :1/60
POSITION2 SEL :1/120
POSITION3 SEL :1/250
POSITION4 SEL :1/500
POSITION5 SEL :1/1000
POSITION6 SEL :1/2000
POSITION2 SEL :1/120
POSITION3 SEL :1/250
POSITION4 SEL :1/500
POSITION5 SEL :1/1000
POSITION6 SEL :1/2000
1
Press the SHUTTER switch from ON to SEL.
SHUTTER switch
2
Press the SHUTTER switch to the SEL position again,
and repeat this until the desired mode or speed is
displayed.
When all the modes and speeds are displayed, the
display will change in the sequence shown below.
and repeat this until the desired mode or speed is
displayed.
When all the modes and speeds are displayed, the
display will change in the sequence shown below.
Viewfinder screen displays relating to the shutter
For details, refer to “4-7 Viewfinder screen status displays.”
POSITION
1
POSITION
2
POSITION
3
POSITION
4
POSITION
5
POSITION
6
Standard mode
SYNCHRO SCAN
mode
Chapter 4 Adjustments and settings for recording
(continued)
1
Press the SHUTTER switch from ON to SEL to establish
the SYNCHRO SCAN mode.
the SYNCHRO SCAN mode.
2
In the SYNCHRO SCAN mode, it is possible to change
the shutter speed continuously by operating the
SYNCHRO SCAN (+ and –) buttons.
the shutter speed continuously by operating the
SYNCHRO SCAN (+ and –) buttons.
4-3-3 Setting the synchro scan mode
Proceed with operation by following the steps below.
SYNCHRO SCAN (+ and –) buttons
SHUTTER switch
01.AJ-HDX900_P_E(VQT0X86)_E 06.6.22 12:52 PM ページ36