Panasonic AJ-HDX900 Benutzerhandbuch
90
Chapter 6 Maintenance and inspections
6-1 Inspections prior to shooting
Before setting off for a shooting session, perform the
following inspections to verify that the system is functioning
correctly. It is recommended that a color video monitor be
used to check the images.
following inspections to verify that the system is functioning
correctly. It is recommended that a color video monitor be
used to check the images.
6-1-1 Preparation for inspections
6-1-2 Inspecting the camera unit
1
Insert a fully charged battery.
1
Set the zoom to the motorized zoom mode, and check
its operations in this mode.
Check that the image changes when the zoom is set to
the telephoto and wide-angle positions.
its operations in this mode.
Check that the image changes when the zoom is set to
the telephoto and wide-angle positions.
2
Set the zoom to the manual zoom mode, and check its
operations in this mode.
Turn the manual zoom lever, and check that the image
changes when the zoom is set to the telephoto and
wide-angle positions.
operations in this mode.
Turn the manual zoom lever, and check that the image
changes when the zoom is set to the telephoto and
wide-angle positions.
3
Set the aperture to the auto adjustment mode, point the
lens at some objects with different brightness levels, and
check that the auto aperture adjustment works.
lens at some objects with different brightness levels, and
check that the auto aperture adjustment works.
4
Set the aperture to the manual adjustment mode, turn
the aperture ring, and check that the manual aperture is
adjusted.
the aperture ring, and check that the manual aperture is
adjusted.
5
While holding down the auto instantaneous aperture
adjustment button, point the lens at some objects with
different brightness levels, and check that the auto
instantaneous aperture adjustment function works.
adjustment button, point the lens at some objects with
different brightness levels, and check that the auto
instantaneous aperture adjustment function works.
6
Return the aperture to the auto adjustment mode, switch
the GAIN switch setting to L, M and H, and check that:
the GAIN switch setting to L, M and H, and check that:
≥
The aperture is adjusted for objects of the same
brightness level in tandem with the switching of the
gain setting.
brightness level in tandem with the switching of the
gain setting.
≥
The gain displayed on the viewfinder screen is
switched in tandem with the switching of the gain
setting.
switched in tandem with the switching of the gain
setting.
7
When a lens with an extender has been installed, set the
extender to the operating position, and check that it
works properly.
extender to the operating position, and check that it
works properly.
2
Set the POWER switch to ON, and check that the
HUMID display has not come on and that at least 5
segments of the BATTERY display are lighted.
HUMID display has not come on and that at least 5
segments of the BATTERY display are lighted.
≥
If the HUMID display has come on, wait until it goes
off.
off.
≥
If fewer than 5 segments of the BATTERY display
have lighted, replace the battery with one having an
adequate charge.
have lighted, replace the battery with one having an
adequate charge.
4
After checking the following points, insert the cassette
tape and close the cassette holder.
tape and close the cassette holder.
≥
The cassette tape must not be set to the accidental
erasure prevention mode.
erasure prevention mode.
≥
There must be no tape slack.
≥
The tape must be free from condensation.
3
Check that there are no cables near the cassette holder
or top panel, and then press the EJECT button to open
the cassette holder.
or top panel, and then press the EJECT button to open
the cassette holder.
1
2
3, 4
01.AJ-HDX900_P_E(VQT0X86)_E 06.6.22 12:53 PM ページ90