Panasonic AJ-HDX900 Benutzerhandbuch
91
6
6-1-3 Inspecting the VTR unit
Perform all the steps outlined in section “1. Tape travel
inspection” through section “4. Earphone and speaker
inspection” one after the other.
inspection” through section “4. Earphone and speaker
inspection” one after the other.
1. Tape travel inspection
1
Set the VTR SAVE/STBY switch to SAVE, and check
that the SAVE lamp inside the viewfinder lights.
that the SAVE lamp inside the viewfinder lights.
2
Set the VTR SAVE/STBY switch to STBY, and check
that the SAVE lamp goes off.
that the SAVE lamp goes off.
3
Set the TCG switch to R-RUN.
4
Set the DISPLAY switch to CTL.
5
Press the unit’s REC START button, and check that:
≥
The tape reels rotate.
≥
The figure shown on the counter display changes.
≥
The REC lamp inside the viewfinder lights.
≥
The RF and SERVO displays do not appear in the
display window.
display window.
6
Press the unit’s REC START button again. Check that
the tape stops and the REC lamp inside the viewfinder
goes off.
the tape stops and the REC lamp inside the viewfinder
goes off.
7
Use the lens VTR button to check the same operations
as in steps 5 and 6.
as in steps 5 and 6.
8
Press the RESET button, and check that “00:00:00:00”
appears on the counter display.
appears on the counter display.
9
Set the LIGHT switch to ON, and check that the display
window illuminates.
window illuminates.
10
Press the REW button, and after the tape has been
rewound for a few seconds, press the PLAY/PAUSE
button.
Check that the tape is recorded, played back and
rewound properly.
rewound for a few seconds, press the PLAY/PAUSE
button.
Check that the tape is recorded, played back and
rewound properly.
11
Press the FF button, and check that the tape is fast
forwarded properly.
forwarded properly.
2. Automatic audio level adjustment function
inspection
1
Set the AUDIO SELECT CH1 and CH2 switch to AUTO.
2
Set the AUDIO IN CH1 and CH2 switches to FRONT.
3
Point the microphone connected to the MIC IN jack at a
suitable sound source, and check that the changes in
the level displays for both CH1 and CH2 reflect the
changes in the strength of the sound.
suitable sound source, and check that the changes in
the level displays for both CH1 and CH2 reflect the
changes in the strength of the sound.
3. Manual audio level adjustment function
inspection
1
Set the AUDIO IN CH1 and CH2 switches to FRONT.
2
Set the AUDIO SELECT CH1 and CH2 switch to MAN.
3
Turn the AUDIO LEVEL CH1 and CH2 controls.
Check that when they are turned clockwise, the level
displays increase.
Check that when they are turned clockwise, the level
displays increase.
4. Earphone and speaker inspection
1
Set the VTR SAVE/STBY switch to STBY.
2
Turn the MONITOR control, and check that the speaker
volume changes.
volume changes.
3
Connect the earphones to the PHONES jack.
Check that the sound from the speaker is muted, and
that the microphone’s sound is heard in the earphones.
Check that the sound from the speaker is muted, and
that the microphone’s sound is heard in the earphones.
4
Turn the MONITOR control, and check that the
earphone volume changes.
earphone volume changes.
Chapter 6 Maintenance and inspections
(continued)
01.AJ-HDX900_P_E(VQT0X86)_E 06.6.22 12:53 PM ページ91