Panasonic AJ-HDX900 Benutzerhandbuch

98

Lights for 90 minutes following the release of the
condensation detection after the condensation
formation was detected.

“HUMID” display lights if condensation is
detected.
“HUMID” display flashes for an additional 10 to
90 minutes after condensation detection is
canceled.

Flashes 4 times per second for 90 minutes after
condensation detection is canceled.

“HUMID” display flashes from the time
condensation is detected until 90 minutes after
the condensation detection is released.

Sounds continuously (4 times a second during
recording).

Condensation has formed.

The recording operation continues but if the tape
sticks, recording will stop.
For 80 minutes after the condensation detection
is released, the drum is rotated and no
operations are accepted.

Stop the tape travel and turn off the power.  If the
“HUMID” display fails to be cleared even when
the power is turned back on, wait until it clears.

When an error or a problem is detected immediately after the power is turned on or while an operation is underway, the
WARNING lamp and lamps inside the viewfinder serve to alert the user.

<Note>
Items are displayed in the following sequence of priority: WARNING lamp > tally lamp > warnings inside the viewfinder.  The
display accords with this sequence when more than one error has occurred at the same time.  However, WIRELESS RF may
not be displayed depending on the menu setting selected.

Flashes four times a second.

“SLACK” appears and an error code flashes.

Flashes four times a second.

“SLACK” appears and an error code lights up.

Sounds continuously.

Motor, solenoid or other mechanism-related
trouble, etc.

Operation is stopped.  Power is turned off if
solenoid trouble has been detected.

Check  “6-3-2 Error codes,” and consult your
dealer.

Flashes four times a second (for at least 3
seconds during recording).

The code 11 display lights.

Flashes four times a second (for at least 3
seconds during recording).

REC WARNING display flashes (for at least 3
seconds during recording).

Sounds four times a second (for at least 3
seconds during recording).

Problem with the recording control signal.

Recording continues but the signals may not be
recorded correctly while the warning remains
displayed.

Rewind the tape or replace the cassette tape.

Lights (during stop and standby OFF).

The bar display that shows the remaining tape
amount starts flashing.

Flashes four times a second (during stop and
standby OFF).

“

= END” flashes (during stop and standby

OFF).

Sounds continuously (during stop and standby
OFF).

The tape has come to its end.

Operation is stopped during recording, playback
and fast forwarding.

Rewind the tape or replace the cassette tape.

Lights.

The bar display that shows the remaining battery
charge starts flashing.

Flashes once a second.

BATT LED lights.

Sounds continuously.

The battery charge is now depleted.

All operations are stopped, and the tape is
unloaded.  Only cassette tape eject is accepted.

Replace the battery.

01.AJ-HDX900_P_E(VQT0X86)_E  06.6.22  12:53 PM  ページ98