Panasonic AJ-HDX900 Benutzerhandbuch

99

Flashes four times a second (during recording
and playback).

“SERVO” display lights (during recording and
playback).

Flashes four times a second (during recording
and playback).

“SERVO” display lights (during recording and
playback).

Sounds four times a second (during recording
and playback).

The servo is disturbed.

Operation continues but the unit may not operate
correctly.

Turn off the power and consult your dealer.  The
warning display may flash for a moment and then
disappear when tape transport commences: this
is normal and not indicative of a failure or
malfunctioning.

Flashes four times a second (during recording).

“RF” display flashes (during standby and
recording).

Flashes four times a second (during recording).

“RF” display lights (during recording).

Sounds four times a second (during recording).

The video heads have become clogged.  There
is a problem in the video system.

The cleaning rollers are activated to clean the
heads (for a maximum of 3 seconds).
Recording continues but the signals may not be
recorded correctly.
The indications on LCD screen are retained until
the REC/PAUSE status is established.  They go
off as soon as the unit transfers from the
REC/PAUSE mode to another mode.

Clean the heads.  If the signals cannot be
recorded correctly even after cleaning, consult
your dealer.

Flashes four times a second (during standby and
recording).

No indication

Flashes four times a second (during recording).

“WIRELESS RF” display lights for at least 3
seconds during recording.

Sounds four times a second (for at least 3
seconds during standby and recording).

Poor wireless signal reception.

Operation continues but the signals from the
wireless microphone cannot be received.

Check the microphone’s power supply and the
reception condition of the receiver.

Flashes once a second.

The bar display that shows the remaining battery
charge starts flashing.

Flashes once a second.

BATT LED starts flashing.

Sounds four times a second.

The battery charge is nearly depleted.

Operation continues.

Replace the battery when it becomes necessary.

Flashes once a second (during recording).

The bar display that shows the remaining tape
amount starts flashing.

Flashes once a second (during recording).

≥

The remaining tape display starts flashing (in
the EE mode).

≥

“

=” flashes for 3 seconds one minute before

the tape reaches the end.

Sounds once a second.

The tape is close to its end (about 2 minutes
remain).

Operation continues.

Replace the cassette tape when it becomes
necessary.

Flashes four times a second.

“1394 E-22” display flashes.

Flashes four times a second.

When error code 92 appears, “1394 INITIAL
ERROR” display lights (during standby).

Sounds four times a second.

There is something wrong with the signals
supplied to the DVCPRO connector.

Operation continues, but something is wrong with
the signals supplied to the DVCPRO connector.

Check the IEEE 1394 cable and DVCPRO
connector connections and the settings of the
external units or menu settings, and then turn the
power off and back on.
If the warning display is not cleared, check “6-3-2
Error codes,” and consult your dealer.

01.AJ-HDX900_P_E(VQT0X86)_E  06.6.22  12:53 PM  ページ99