Panasonic PV-GS80 Betriebsanweisung

Before using

LSQT1121

ª

When this product is purchased, the battery is not 
charged. Charge the battery before using this 
product.
≥Battery charging time. (

)

≥We recommend using Panasonic batteries. 

(

, 

)

≥If you use other batteries, we cannot guarantee 

the quality of this product.

≥If the DC Cable is connected to the AC adaptor, 

then the battery will not get charged. Remove 
the DC Cable from the AC adaptor.

ª

Lights up: Charging
Goes off: Charging completed
Flashing: The battery is over discharged 

(discharged excessively). In a while, 
the lamp will light up and normal 
charging will start.
When the battery temperature is 
excessively high or low, the [CHARGE] 
lamp flashes and the charging time will 
be longer than normal.

ª

Connect the DC Cable to this product.
≥The output plug of the AC Cable is not 

completely connected to the AC adaptor jack. 
As shown in 

1, there is a gap.

≥Do not use the power cord for other 

equipment since the power cord is exclusively 
designed for this Camcorder. Do not use the 
power cord from other equipment for this 
Camcorder.

ª

Push the battery against the battery holder and 
slide it until it clicks.

ª

While sliding the [BATTERY] lever, slide the 
battery to remove it.

≥Hold the battery with your hand so it does not 

fall.

≥Before removing the battery, be sure to set the 

[OFF/ON] switch to [OFF].

Danger of explosion if battery is incorrectly 
replaced. Replace only with the same or 
equivalent type recommended by the 
manufacturer. Dispose of used batteries 
according to the manufacturer’s instructions.

1

BATTERY

S5660.book  14 ページ  ２００６年１０月３０日　月曜日　午後６時５６分