Panasonic PV-GS55 Benutzerhandbuch

Seite von 88
Editing Mode
-47-
To Cancel Audio Dubbing
Press the [
;] Button 
 on the Remote 
Controller.
The Palmcorder is in the Still Playback Mode 
again.
To Play Back the Sound Recorded by 12bit 
Audio Dubbing
Set [TAPE PLAYBACK MENU] >> [PLAYBACK] 
>> [12bit AUDIO] >> [ST2] or [MIX].
ST1: It plays back only the original sound.
ST2: It plays back only the sound added by Audio 
Dubbing.
MIX: It plays back both the original sound and the 
sound added by Audio Dubbing 
simultaneously.
To Dub Audio While Listening to a 
Pre-recorded Sound
When pausing the audio dubbing, set the 
[12bit AUDIO] on the [PLAYBACK] Sub-Menu to 
[ST2] and you can check the pre-recorded sound.
When a microphone is used for audio dubbing, 
use headphones to listen to the pre-recorded 
sound while dubbing the audio. (When using 
headphones, set [AV JACK] on the [AV IN/OUT] 
to [OUT/PHONES].) When the line input is used, 
you can dub audio while listening to the 
pre-recorded sound from the speaker.
≥For other notes concerning this item, see 
Copying on an S-VHS (or a VHS) 
Cassette
(Dubbing)
After connecting the Palmcorder and the VCR 
as illustrated, start the following procedures.
1 AV Cable
2 S-Video Cable
≥Be sure to press the [OSD] Button (
) on the 
Remote Controller prior to copying so that no 
indications are visible. Otherwise, the displayed 
tape counter and function indications are also 
copied.
Palmcorder:
1
Insert the recorded Cassette.
VCR:
2
Insert an unrecorded Cassette with an 
erasure prevention tab.
≥If various setups (such as external input, tape 
speed, etc.) are required, please refer to the 
operating instructions of your VCR.
Palmcorder:
3
Press the [
1] Button to start playback.
VCR:
4
Start recording.
5
Press the Pause or Stop Button to stop 
recording.
Palmcorder:
6
Press the [
] Button to stop playback.
1
2
[VIDEO IN]
[AUDIO IN]
[S-VIDEO IN]
S-VIDEO
IN/OUT
AV IN/OUT 
PHONES
REMOTE/MIC
DV
(PLUG IN POWER)
PV-GS55PP_Eng.book  47 ページ  2004年2月10日 火曜日 午前11時51分