Panasonic PV-GS320 Benutzerhandbuch

Before using

LSQT1091

When Quick Start is ON the battery power is still 
being consumed, even when the LCD Monitor 
and the Viewfinder are closed.
The Camcorder will resume recording/pause 
mode about 1.7 seconds after the LCD Monitor 
and the Viewfinder are reopened.
≥Please note in Quick Start Mode approximately 

half the pause recording power is being 
consumed.
Using Quick Start Mode will reduce the battery 
recording/playback time.

≥This is only activated in the following cases.

≥While using the battery

A tape or a card is inserted, while the Tape 
Recording Mode is set.
A card is inserted, while the Card Recording 
Mode is set.

≥While using the AC adaptor

Quick Start can be used even if a tape/card 
is not inserted.

≥Set to Tape/Card Recording Mode.

Set [SETUP] >> [QUICK START] >> [ON]. 
(

)

≥The Status indicator lights green and the unit 

goes into quick start standby mode.

≥The Camcorder will not go into quick start 

standby mode unless the LCD monitor is 
closed and the viewfinder is retracted.

≥The Status indicator lights red and the 

Camcorder is put into recording pause 
approx. 1.7 seconds after it is turned on.

ª

Set [SETUP] >> [QUICK START] >> [OFF]. 
(

)

≥If the [OFF/ON] switch is set to [OFF] while the 

unit is in quick start standby mode, the power 
turns off.

≥If the standby continues for approx. 30 minutes, 

then the Status indicator will go off and the 
Camcorder will be completely turned off.

≥In the following cases, quick start is canceled 

and the power turns off.

≥When the Mode dial is moved.
≥When the battery or AC adaptor is removed.
≥When both the tape and card are removed 

while using the battery in Tape Recording 
Mode.

≥When the card is removed while using the 

battery in Card Recording Mode.

≥When the Camcorder is quick-started with the 

white balance on automatic, it may take some 
time until the white balance is adjusted if the 
scene being recorded has a light source 
different from the scene last recorded. (When 
the MagicPix function is used, however, the 
white balance of the scene last recorded is 
retained.) 

≥If the power is turned on in quick start standby 

mode, the zoom magnification becomes 1

t and 

the picture size may differ from what it was 
before quick start standby.

≥If [POWER SAVE] (

) is set to [5 MINUTES] 

and the unit automatically goes into quick start 
standby mode, set the [OFF/ON] switch to 
[OFF], then to [ON] again. Also, close the LCD 
monitor and retract the viewfinder and then 
open the LCD monitor or extend the viewfinder 
again.

OFF

ON

OFF

ON

LSQT1091_ENG.book  19 ページ  ２００６年１１月２７日　月曜日　午後１時１７分