Panasonic HDC-TM300P/PC Benutzerhandbuch

VQT1Z09

 Charging the battery

 Connect the AC cable to the AC adaptor and 

the AC outlet.

 Insert the battery into the AC adaptor by 

aligning the arrows.

 Inserting the battery

Install the battery by inserting it in the direction 
shown in the figure.

 Insert the battery until it clicks and locks.

 Inserting/removing an SD card

1) Open the LCD monitor.
 Check that the access lamp has gone off.
2) Open the SD card cover by sliding the OPEN 

lever 

.

3) Insert/remove the SD card.
 Face the label side  in the direction shown in 

the illustration and press it straight in as far as 
it will go.

 Press the center of the SD card and then pull it 

straight out.

4) Securely close the SD card cover.
 Securely close it until it clicks.

 How to turn on the power

Turn on the power by changing the mode to 

, 

 or 

 while pressing the lock release 

button 

.

 To turn off the power, change the mode to OFF.

 When this unit is accessing the SD card or 

built-in memory, the access lamp lights up.

Lights up:
Charging
Goes off:
Charging completed

OPEN

 Rotate the mode dial while at the same 

time pressing in the lock release button if 
changing from OFF to another mode.

 Align with .

 Status indicator 

HDC-TM300

 Rotate the mode dial while at the same 

time pressing in the lock release button if 
changing from OFF to another mode.

 Align with .

 Status indicator 

OFF

HDC-HS300