Panasonic HDC-HS100PC Benutzerhandbuch

Seite von 160
40
VQT1T93
This unit will resume recording pause mode 
about 0.6 seconds after the LCD monitor is 
reopened.
≥ When in quick start standby mode about 
70% of the power used in recording pause 
mode is being consumed, so the recording 
time will be reduced.
¬Rotate the mode dial to select 
.
1
Set the LCD/EVF select switch to 
LCD. (
35)
2
Select the menu. (29)
3
Close the LCD monitor while the 
mode dial is set to 
.
The status indicator A flashes green and the unit 
goes into quick start standby mode.
≥ The lens cover does not close.
4
Open the LCD monitor.
The status indicator A lights red and the unit is 
put into recording pause approx. 0.6 seconds 
after it is turned on.
≥ Set [QUICK START] to [OFF] to cancel the 
quick start mode.
≥ Quick start standby mode is canceled if
jabout 5 minutes has elapsed
jmode dial is set to 
junit is turned off
≥ Time for quick start will be more than 0.6 
seconds slower in the following conditions.
jWhen 24p digital cinema is used
jWhen the unit is exposed to vibration or 
shock
≥ In the quick start mode, it may take some time 
for automatic white balance to adjust, if the 
scene being recorded has a light source 
different from the scene last recorded. (When 
the MagicPix function is used, however, the 
white balance of the scene last recorded is 
retained.)
≥ In the quick start mode, the zoom 
magnification becomes 1k and the picture size 
may differ from what it was before quick start 
standby mode.
≥ If [POWER SAVE] (
l 31) is set to 
[5 MINUTES] and the unit automatically goes 
into quick start standby mode, close the LCD 
monitor and then open it again.
(Only when recording to an SD card)
The unit is put into recording pause approx. 
1.9 seconds when the mode dial is set to 
 
from OFF.
≥ Start time will not shorten if you are recording 
to a HDD, or if there is no SD card inserted.
¬Rotate the mode dial to select 
.
1
Select SD card as a media to 
record from the menu. (
29)
2
Select the menu. (29)
≥ This function’s default setting is [ON].
≥ Set [QUICK POWER ON] to [OFF] to cancel 
the quick power on.
≥ In the quick power on mode, the zoom 
magnification becomes 1k and the picture size 
may differ from what it was before turning 
power off.
Quick start
[SETUP] 
# [QUICK START] # [ON]
Quick power on
[MEDIA SELECT] 
# [SD CARD]
[SETUP] 
# [QUICK POWER ON] # [ON]
HDCHS100P-VQT1T93_ENG.book  40 ページ  2008年7月14日 月曜日 午後1時36分