Panasonic AG-HPX600P Benutzerhandbuch

– 93 –

Chapter 5 Preparation — Mounting and adjusting the lens

Mounting and adjusting the lens

Mounting the lens

Raise the lens lever and remove the mount cap.

Lens lever

Mount cap

Align the indentation at the top center of the lens mount with

the center mark of the lens to mount the lens.

Mark

Lower the lens lever to firmly clamp the lens.

Secure the cable through the cable clamp and connect it to

the <LENS> terminal.

Cable clamp

<LENS> terminal

NOTE

tFor details on the current from the <LENS> terminal, refer to

“Details of the connector signals” (page 173).

Perform lens flange back adjustments.

For details, refer to “Flange back adjustment” (page 93).

NOTE

tFor handling the lens, refer to the lens operating instructions.

tWhen the lens is removed, install the mount cap to protect the

device.

Flange back adjustment

If images are not clearly focused at both telephoto and wide-angle positions during zoom operations, adjust the flange back (distance from the lens
mounting surface to the image formation surface).
Once adjusted, the flange back does not need to be readjusted as long as the lens is not changed.

NOTE

tRefer to the lens operating instructions for guidance on adjustment methods and positions of lens parts.

For a normal lens

Mount the lens on the camera.

Make sure to connect the lens cable.

Set the lens iris to manual, and fully open the iris.

Approximately 3 m