Panasonic DMC-FT4/DMC-TS4 VQT4E30 F0212MG0 Benutzerhandbuch

Applicable modes: 

With the current atmospheric pressure as a reference, 
it is displayed on the graph within the range of j10 hPa 

to _10 hPa.

(Atmospheric pressure out of range cannot be 
displayed in details)

A 24 hours earlier
B Present
C Time periods for which history was not recorded (white 

portion)

D Atmospheric pressure information in 90 minute intervals

•

The barometer is an indicator of changes between fine weather and rain.

–

When the atmospheric pressure rises: Weather tends to recover

–

When the atmospheric pressure drops: Weather tends to worsen

•

In the following cases, atmospheric pressure is not recorded on the graph.

–

When [GPS Setting] is set to [ON], the battery is low, and the power is off

–

When [Airplane Mode] is set to [ON] and the power is off

–

When [Sensor Settings] is set to [OFF]

–

[Underwater]

•

When the displayable range (current atmospheric pressure of j10 hPa to _10 hPa from the 

reference pressure) is exceeded, the atmospheric pressure will not be displayed correctly.

∫ About the measured altitude and atmospheric pressure
•

Altitude value may show errors depending on the change in atmospheric pressure compared to 

areas such as locations with altimeter reference signs. Perform frequently with [Adjust] in 

[Altimeter].

•

Altitude announced onboard an airplane is measured using the atmospheric pressure 

surrounding the airplane. It does not match the altitude actually measured inside the airplane.

•

Even if the unit is fixed at a constant altitude, the measured altitude may fluctuate due to the 

effects of change in atmospheric pressure.

In coastal areas, the altitude changes by 1 m (3.3 feet) per 0.12 hPa.

•

Altitude and atmospheric pressure may not be measured 

accurately in the following cases:

–

When there is a significant change in weather conditions 

(Pressure and air temperature)

–

When there is a movement with a rapid change in altitude

–

When pressure is applied to the front or rear of this unit

¢1

–

When this unit is wet (after using underwater, etc.)

¢2

–

When closing the side door

¢2

¢1 Hold this unit as shown in the figure when measuring.
¢2 It will adapt to the ambient atmospheric pressure within a few minutes, and display correct 

measurement values.

24H

24H

24H

0H

0H

0H

−

−

1013hPa

1013hPa

1013hPa

+10 hPa

-10 hPa







