Panasonic AG-HMC70P Benutzerhandbuch

ª Unit operations

≥Is the battery fully charged?

# Charge it with the AC adaptor. (l 29)

≥The battery protection circuit may have operated. Attach the battery 

to the AC adaptor for 5 to 10 seconds. If the unit still cannot be 
used, the battery is faulty.

≥Did you set the power save function to [5 MINUTES]?

# If the power save function is set to [5 MINUTES], then when the 

camera is not operated for approximately 5 minutes, the power is 
automatically shut off to save the battery.
To resume recording, turn the power back on.
The power will not turn off automatically when the power save 
function (l 104) is set to [OFF].

≥Is the battery low?

# If the remaining battery power indication is flashing or the 

message “LOW BATTERY.” is displayed, the battery has run 
down. Charge the battery. (l 29)

≥This is the sound of the lens moving and is not a defect. This sound 

will no longer be heard when the unit’s power is turned on. 

≥Is the battery fully charged?

# Charge it with the AC adaptor. (l 29)

≥Are you using the battery in an extremely cold place?

# The battery is affected by ambient temperature. In cold places, 

the operating time of the battery becomes shorter.

≥Has the battery worn out?

# The battery has a limited life. If the operating time is still too short 

even after the battery is fully charged, the battery has worn out 
and can no longer be used. 

≥The remaining battery capacity indication is an approximation.

If you think the remaining battery capacity indication is not displayed 
correctly, fully charge the battery, discharge it and then charge it 
again. (Even if this operation is performed, it may not be possible to 
display the remaining battery capacity correctly if the battery was 
used for a long period of time where the temperature was low or 
high or if the battery was repeatedly charged.)

VQT1Q93_ENG_PP.book  111 ページ  ２００８年３月６日　木曜日　午後５時４２分