Panasonic AG-HPX250EN Benutzerhandbuch
107
Editing
• External devices cannot be controlled via
1394 connection when AVC-Intra format or
DVCPRO HD native recording is selected.
• Backup recording does not work in three
of the special recording modes: Interval
recording, One-shot recording and Loop
recording. (Page 44 – 46)
• Please note that when performing backup
recording to a connected external device
with the time code of this unit set to REC
RUN, continuing recording when there is
no more free space on the P2 card inserted
into this unit causes the time code output
from the DVCPRO/DV terminal to halt.
• Backup recording may not be performed by
external devices if you perform recording
start → stop → recording start in quick
succession.
Precautions in 1394 connections
• The camera-recorder does not supply power via
the cable.
• Observe the following in connections using a
1394 cable.
· Connect this unit to only one other device.
· Do not expose the DVCPRO/DV connector to
· Do not expose the DVCPRO/DV connector to
excessive force when connecting a 1394 cable
to avoid damaging the connector.
to avoid damaging the connector.
· If an error (1394 INITIAL ERROR) should occur
when making a connection, reinsert the 1394
cable or turn the camera-recorder off and then
turn it back on again.
cable or turn the camera-recorder off and then
turn it back on again.
· Make sure that the camera-recorder and all
connected devices are connected to ground
(or connected to a common ground). If the
equipment cannot be connected to ground, turn
off all connected devices before connecting or
disconnecting an IEEE1394 cable.
(or connected to a common ground). If the
equipment cannot be connected to ground, turn
off all connected devices before connecting or
disconnecting an IEEE1394 cable.
· When connecting the unit to a device with a
4-pin connector, connect the cable to the 6-pin
connector on the camera-recorder first.
connector on the camera-recorder first.
• Be sure to properly connect the 1394 cable to
the DVCPRO/DV connector on a computer with a
6-pin connector. Note that inserting the plug the
wrong way round may damage the connector.
6-pin connector. Note that inserting the plug the
wrong way round may damage the connector.
6-pin type 4-pin type
• AV signals may be disrupted when connected
devices are turned on and off or when the
interface cable is connected or disconnected.
interface cable is connected or disconnected.
• It may take the system a few seconds to stabilize
after switching input signals or changing modes.
Start recording after the system has stabilized.
Start recording after the system has stabilized.
• The AUDIO LEVEL control does not work in
recordings that involve IEEE1394 interface input
or output signals.
or output signals.