Panasonic AG-HPX250EN Benutzerhandbuch

Loop recording (LOOP REC)

• When two P2 cards are inserted in the P2 card

slots, each card is recorded in succession.

• When there is no longer any space left on the

second cards, recording starts over from the first
card by recording new clips over saved old clips.

· “Splitting clips recorded on P2 cards” (Page 14)

Before

starting loop

recording

First loop

recording

Second loop

recording

Recording start

1st card

2nd card

No recording

Recorded

Recording will be made on the areas with no

recording consecutively (A, B, then C). When all

areas on all cards are recorded, new recording

(C) will be made by overwriting the area A.

Check that the SYSTEM SETUP screen is

set up as described on page 43.

• Refer to the section “Using the setup menus”

(Page 28 of Vol. 1) for menu operation.

Select LOOP in the menu option REC

FUNCTION in the RECORDING SETUP

screen. (Page 141)

Press the START/STOP button.

• Recording starts.
• Press the START/STOP button to stop

recording.

• To cancel this function, turn the camera-

recorder off or select NORMAL in the REC
FUNCTION item.

• The following indications appear to the left of

the operation status display.

· During recording: “L-REC” stays lit.
· During a pause: “L-PAUSE” stays lit.
· When remaining memory is low: “P2 LACK

L-” blinks.

•

Use two P2 cards with at least one minute

of remaining recording time.

•

The mode check screen shows standard

recording time depending on recording

format as remaining P2 card time. When

loop recording is stopped right after

deleting old data, the time of recordings on

the card may be shorter than indicated.

•

This function is not available during

IEEE1394 input.

•

The pre-recording and one-clip recording

functions are not available.

•

Canceling this function may take some

time. The succeeding operations are not

available until the P2 CARD ACCESS LED

goes from blinking to steady lighting.

•

During loop recording, the access LEDs

for all P2 cards used in the recording light

orange or blinks. Note that removing any of

the P2 cards will terminate loop recording.

•

Irregularity in the input GENLOCK reference

signal during loop recording may terminate

recording.

Using special recording modes (continued)