Panasonic AG-AC130P Benutzerhandbuch

Seite von 106
16
 
Repairing memory cards
 
„
For AVCHD mode
Never remove the memory card or disconnect 
the battery or DC cord while the memory card 
access lamp is flashing, since this may damage 
the memory card. If the memory card has been 
removed while the memory card access lamp 
was flashing, or the power was cut because the 
battery or DC cord has been disconnected during 
recording or the recording finalization process, a 
repair verification screen will be displayed the next 
time the power is switched on in order to allow 
errors to be repaired.
Select [YES] to begin repair, and when repair is 
completed, [REPAIR FINISHED] will be displayed 
and the camera will switch to the shooting paused 
screen.
Select [NO] to switch directly to the shooting 
paused screen without repair.
 
Memory cards cannot be repaired with the 
camera if [NO] is selected, but can still be 
repaired by using the AVCCAM Restorer* 
contents repair software.
 
A memory card on which an error occurred can 
be repaired by either using the camera that was 
used for shooting, or the AVCCAM Restorer 
contents repair software.
 
A repair confirmation message may be displayed 
after inserting a memory card which has no error, 
but repair will not be performed even when [YES] 
or [NO] is selected.
 
Repair may take up to approximately 20 minutes 
depending on the places where the errors 
occurred on the memory card.
 
Use a battery with an adequate charge, or the AC 
adaptor.
 
If the repair operation has failed [SYSTEM 
ERROR TURN POWER OFF] will be displayed. 
In this case, use the AVCCAM Restorer contents 
repair software.
 
Depending on the status of the data, it may not 
be possible to restore all data completely. In this 
case, it will no longer be possible to play back the 
clips that were recorded before the power was 
turned off.
 
Clips with a total shooting time of less than 10 
seconds may not be repaired.
 
Indexes attached during shooting cannot be 
repaired.
 
To repair the two memory cards that recorded 
video with SIMUL REC, follow the instructions 
displayed on the repair verification screen and 
repair each of the memory cards.
*  AVCCAM Restorer is included on the supplied CD-
ROM. Refer to install.txt for the installation method. 
For details on how to use it, read the Operating 
Instructions (PDF file).
The AVCCAM Restorer can also be downloaded 
from the following website.
http://pro-av.panasonic.net/
 
„
For DV mode
For repair in DV mode, refer to “Repairing clips 
(only in DV mode)” (Page 58).