Panasonic AG-AC130P Benutzerhandbuch

20

When the screen of the camera is dark, you can 
make the screen bright by raising the gain.

Normally, put it in this position.
(Factory setting is 0 dB)

 Raises the gain of the camera image amp. 
(Factory setting is 6 dB)

 Raises the gain of the camera image amp. 
(Factory setting is 12 dB)

• Gain value of <L>/<M>/<H> can be changed 

in the [LOW GAIN]/[MID GAIN]/[HIGH GAIN] 
item on the setup menu [SW MODE] screen. 
(Page 82)
Especially when gain adjustment is necessary, 
assign the [S.GAIN] item to any of the 
<USER1> - <USER3> buttons. Each time the 
assigned button is pressed, you can switch 
between normal gain/super gain. When 
setting super gain, select [24dB] or [30dB] in 
the [SUPER GAIN] item on the [SW MODE] 
screen.

• When other than [OFF] is selected with the 

[AGC] item on the setup menu [AUTO SW] 
screen, auto gain is on during auto mode 
regardless of the position of the <GAIN> 
switch. (Page 84)

When natural light is strong, use the <ND FILTER> 
dial to switch the ND filter (light intensity adjustment 
filter) to use.

ND filter is not used.

Intensity of light is cut to approx. 1/4.

Intensity of light is cut to approx. 1/16.

Intensity of light is cut to approx. 1/64.

To reproduce white accurately, adjust the 
proportion of the primary colors RGB. When the 
white balance is wrong, not only the reproduction 
of white is bad, but also the color tone of the whole 
screen becomes bad.
When shooting in manual mode, if light conditions 
change, always adjust the white balance.
The adjusted value for white balance can be saved 
on the <A> and <B> positions of the <WHITE BAL> 
switch.
Also, you can use the preset values already in the 
memory. Use the memory according to shooting 
conditions.