Sharp VL-NZ100S Benutzerhandbuch

TAPE-VCR

The LCD monitor screen functions as a handy
playback monitor. Nothing needs to be
connected, allowing instant on-screen play-
back with the sound through the built-in
speaker.

Set the Media Selection
switch to TAPE.

Hold down the Lock button
and set the Power switch to
VCR.

Press j (or k) on the Operation button
to rewind (or fast forward) the tape to the
desired point.

Press m to begin playback.

Note:
• If you press the REC START/STOP button in

TAPE-VCR mode, the “

” mark appears and

the camcorder enters Recording Standby mode.
If you do not intend to record, press l to turn
the “

” mark off, then press m to begin

playback. This will ensure your previous
recording is not erased (see pages 49, 51).

Press l.

Set the Power switch to OFF without pressing
the Lock button.

Note:
• The tape is automatically rewound when

playback reaches the end of the tape.

TAPE-VCR, TAPE-CAMERA

You can monitor the sound via stereo ear-
phones (commercially available) during
playback or recording. Stereo earphones with a
3.5 mm diameter plug can be used with this
camcorder.

Connect the plug of stereo earphones to the
PHONES jack on the camcorder as shown
below.

Notes:
• Before connecting stereo earphones, turn the

camcorder volume down to the lowest setting.

• The built-in speaker automatically turns off when

stereo earphones are connected to the PHONES
jack.

Lock button

Operation button

Media Selection switch

Power switch

PHONES jack

VL-NZ100H-019-025

02.2.14, 9:59 AM

23