Sony EV-H100s Benutzerhandbuch
51
Troubleshooting
A
ppe
nd
ix
ix
Troubleshooting
Before bringing in your camera for service, check the following as a guide to troubleshooting
the problem. If the problem cannot be corrected, consult your Sony dealer.
the problem. If the problem cannot be corrected, consult your Sony dealer.
Symptom
Cause
Remedy
The picture is not
displayed on the video
monitor connected to the
camera.
displayed on the video
monitor connected to the
camera.
The video cable is not connected
properly.
properly.
Check the connection between
the camera and video monitor.
the camera and video monitor.
The SYSTEM SELECT switch
on the rear of the camera is not
set correctly.
on the rear of the camera is not
set correctly.
Check the selected output signal
format of the camera and the
input signal format of the
connected monitor.
format of the camera and the
input signal format of the
connected monitor.
The VISCA control is not
available with a computer
connected to the camera.
available with a computer
connected to the camera.
The computer is not correctly
connected to the camera.
connected to the camera.
Make sure the connection
between the computer and
camera is made correctly.
between the computer and
camera is made correctly.
Check that the baud rate setting
(9,600 bps or 38,400 bps) is
properly made with the
BOTTOM switch on the bottom
of the camera (page 41).
(9,600 bps or 38,400 bps) is
properly made with the
BOTTOM switch on the bottom
of the camera (page 41).
Check that the SYSTEM
SELECT switch (page 40) is set
to a position in which video
signals are output.
SELECT switch (page 40) is set
to a position in which video
signals are output.
The camera cannot be
operated at all.
operated at all.
-
Stop power to the DC 12 V
connector. After a few moments,
apply power again.
connector. After a few moments,
apply power again.