Hitachi DZ-B35A Benutzerhandbuch

Seite von 167
English
141
During recording
Symptom
Cause and Correction
Reference 
page
Pressing the REC or 
PHOTO button will not 
start recording.
• Is input image copy-guarded?
• Is a finalized disc in the DVD video camera/recorder?
• Is proper type of disc or card inserted?
• Is power switch set to match the recording medium?
− When using DVD-RAM disc.
− When using SD memory card: Set to “P”.
• Is the disc protected or the card locked?
• Does disc or card have remaining recording space?
25, 31, 86, 
100, 110
Recording starts but 
stops immediately.
Is disc scratched or does dirt or fingerprint adhere to it?
Clean the disc. If there is still no improvement, replace the disc.
10
Is some other AV device directly connected to the video/audio 
input/output jack of this DVD video camera/recorder?
If the AV device is connected via several other devices, such as 
AV selector, the video signal may not be transmitted incorrectly. 
In such a case, reduce the number of devices through which the 
video signal is transmitted, or connect AV device directly.
109
Are you attempting to record image from video game or PC?
From some video games or PCs, image cannot be recorded on 
this DVD video camera/recorder.
LCD screen is hard to 
see.
Has brightness of LCD screen been adjusted?
Stop recording and adjust the brightness.
36
Is the DVD video camera/recorder being used outdoors?
Use the viewfinder. When using LCD monitor, adjust its angle so 
that LCD screen is not exposed to direct sunlight.
32
Unevenness appears on 
LCD monitor screen.
Did you press the LCD monitor or the area around it?
If the LCD monitor is pressed, some unevenness will occur. 
Release your hand and leave the LCD monitor for a while: 
Normal display will be restored.
Focus is not correct.
Is it difficult to use auto focus with your subject?
Focus manually.
54
Does “MF” appear?
The DVD video camera/recorder is set to manual focus. Focus 
the subject manually, or release manual focus.
53
Is the diopter control correctly adjusted if you are using the 
viewfinder as a monitor?
Adjust the diopter control.
32
In cases other than the above, set the power switch to “OFF”, and 
then set it to “
O
”, “
N
” or “
P
” again.
31
An error message for 
repair appears.
Repair is only possible when the DVD video camera/recorder is 
powered by the AC adapter/charger. Remove the disc, and then 
insert another disc: The removed disc can later be repaired by 
connecting the AC adapter/charger.
26