Lg Electronics HR931M Benutzerhandbuch

87

Appendix

*5  If the [HDMI] or [Digital Output] option is set 

to [DTS re-encode], the audio output is limited 
to 48 kHz and 5.1Ch. If the [HDMI] or [Digital 
Output] option is set to [DTS re-encode], the 
DTS Re-encode audio is output for BD-ROM 
discs, and the original audio is output for the 
other discs (like [Primary Pass-Thru]).

 

y If [HDMI] option is set to [PCM Multi-CH] and 

[Digital Output] option is set to [Primary Pass-
Thru], it plays Dolby Digital Plus. 

 

y If the HDMI connection is version 1.3 and Dolby 

Digital Plus/Dolby TrueHD is output from HDMI 
OUT jack.

 

y The audio is outputted as PCM 48 kHz/ 

16 bit for MP3/WMA file and PCM  
44.1 kHz/16 bit for Audio CD while playback.

 

y The Dolby TrueHD audio recorded on some Blu-

ray discs consists of Dolby Digital and TrueHD 
audio. Dolby Digital audio is output through 
DIGITAL AUDIO OUT jacks and “DD” displays on 
the screen if TrueHD audio is not output (for 
example, when [HDMI] is set to [PCM Stereo] and 
[Digital Output] is set to [Primary Pass-Thru]).

 

y You must select a digital audio output and 

a maximum sampling frequency that your 
Amplifier (or AV receiver) accepts using [Digital 
Output], [HDMI] and [Sampling Freq.] options on 
the [Setup] menu (see page 33-34). 

 

y With digital audio connection (DIGITAL AUDIO 

OUT or HDMI), Disc Menu button sounds of BD-
ROM may not be heard if the [Digital Output] or 
[HDMI] option is set to [Primary Pass-Thru].

 

y If the audio format of the digital output does 

not match the capabilities of your receiver, the 
receiver will produce a strong, distorted sound 
or no sound at all.

 

y Multi-channel Digital Surround Sound via digital 

connection can only be obtained if your receiver 
is equipped with a Digital Multi-channel decoder.

The internal hard disk drive (HDD) is a fragile piece 
of equipment. Please use the player following the 
guidelines below to protect against possible HDD 
failure.

 

y Do not move the player while it is on.

 

y Install and use a player on a stable, levelled 

surface.

 

y Do not use the player in excessively hot or 

humid places, or in places that may be subject 
to sudden changes in temperature. Sudden 
changes in temperature can cause condensation 
to form inside the player. This can be a cause of 
HDD failure.

 

y While the player is powered on, do not unplug 

from the wall socket or switch the electricity off 
from the breaker switch.

 

y Do not move the player immediately after 

switching it off. If you need to move the player, 
please follow the steps below:

1.  After the message “OFF” is shown in the 

display, wait at least two minutes.

2.  Unplug from the wall socket.

3.  Move the player.

 

y If there’s a power failure while the player is on, 

there is a chance that some data on the HDD will 
be lost.

 

y The HDD is very delicate. If used improperly or 

in an unsuitable environment, it is possible that 
the HDD will fail after a few years of use. Signs 
of problems include playback unexpectedly 
freezing and noticeable block noise (mosaic) in 
the picture. 

 

y However, sometimes there will be no warning 

signs of HDD failure.

 

y If the HDD fails, playback of content will not 

be possible. In this case, contact the LG service 
center by following methods.

Web: http://lgservice.com

 

y The manufacturer disclaims responsibility for loss 

of data contained in internal HDD.

 

y There are some capacities in HDD reserved for 

the file system and timeshift.