Olympus E06 Benutzerhandbuch

Seite von 30
EN 3
En
6
Jumping into the water with the Case in your pocket or in your hand, throwing the Case from a boat 
or ship into the water, and other rough handling may cause water leakage. Please handle with 
sufficient care, when handing it over from hand to hand etc.
7
If the camera on the inside should become wet because of water leakage etc., immediately wipe off 
all moisture and confirm the operation.
8
Be careful not to apply excessive force to the port connector, TTL cable connector, zoom dial or tripod 
seat.
9
Do not push the air vent valve from inside.
0
Please remove the O-ring when traveling by air. Otherwise air pressure may make it impossible to 
open the Case.
a
For safe use of the digital camera in this product, please read the “Instruction Manual” for the digital 
camera carefully.
b
When sealing this product, take sufficient care that no foreign matter gets caught at the O-ring and 
the contact surfaces.
c
The camera’s built-in flash cannot be used when the Case is combined with an external Olympus 
flash. Also, the camera’s built-in flash cannot be popped up if the hot shoe cable is connected to the 
camera’s hot shoe. If the built-in flash is forcibly popped up, the connected flash will not work properly 
and the hot shoe cable may be disconnected from the camera’s hot shoe. In this case, the camera 
may also be damaged.
d
The camera’s built-in flash cannot be used when the camera is in the Case.
PT-E06_EN.Book  Page 3  Thursday, February 26, 2009  5:04 PM