Honeywell 128BPTSIA Benutzerhandbuch
– 27 –
Checking For Open Zones
Using the
✳
✳
✳
✳ READY Key
Before arming your system, all protected doors, windows and other protection
zones must be closed or bypassed (see BYPASSING section). Otherwise the
keypad will display a "Not Ready" message. Using the READY key will
display all zones that are faulted, making it easier for you to secure any open
zones.
zones must be closed or bypassed (see BYPASSING section). Otherwise the
keypad will display a "Not Ready" message. Using the READY key will
display all zones that are faulted, making it easier for you to secure any open
zones.
To show faulted zones:
DISARMED - PRESS
∗ TO SHOW FAULTS
∗ TO SHOW FAULTS
Note: Some keypads light a green LED when
the system is ready. If not lit, the system is not
ready to be armed.
the system is ready. If not lit, the system is not
ready to be armed.
READY
1. Do not enter security code, but simply press
✳ .
FAULT 005 FRONT
UPSTAIRS BEDROOM
Typical fault display
2.
DISARMED
READY TO ARM
Secure or bypass the zones displayed before
arming the system. The "Ready" message will
arming the system. The "Ready" message will
be displayed† when all protection zones have
been either closed or bypassed.
been either closed or bypassed.
† NOTE: All or part of this message may be
replaced by a customized message programmed
by the installer. Bear this in mind whenever
the instructions indicate that the
"DISARMED" or "READY" message will be
displayed.
replaced by a customized message programmed
by the installer. Bear this in mind whenever
the instructions indicate that the
"DISARMED" or "READY" message will be
displayed.