SonicWALL 3 Benutzerhandbuch

79

The SonicWALL TZ 50 Wireless/TZ 150 Wireless/TZ 170 Wireless includes the WLAN interface in 
the Interfaces table on the Network>Settings page.

Clicking the Edit icon for the WLAN interface displays the WLAN Settings window for configuring the 
WLAN properties.

•

The Enable WLAN setting is checked by default to activate the WLAN interface on the 
SonicWALL security appliance.

•

Select WiFiSec Enforcement to require that all traffic that enters into the WLAN interface be 
either IPSec traffic, WPA traffic, or both. With WiFiSec Enforcement enabled, all non-guest wire-
less clients are required to use the strong security of IPSec. The VPN connection inherent in 
WiFiSec terminates at the GroupVPN Policy, which you can configure on the VPN > Settings 
page.

•

If you have not selected WiFiSec Enforcement, you can select Require WiFiSec for Site-to-Site 
VPN Tunnel Traversal to require WiFiSec security for all wireless connections through the WLAN 
zone that are part of a site-to-site VPN.

•

Click Trust WPA traffic to accept WPA as an allowable alternative to IPSec. The SonicWALL TZ 
50 Wireless/TZ 150 Wireless/TZ 170 Wireless supports both WPA-PSK (Pre-shared key) and 
WPA-EAP (Extensible Authentication Protocol using an external 802.1x/EAP capable RADIUS 
server).

•

WLAN IP Address: The IP address of the SonicWALL TZ 50 Wireless/TZ 150 Wireless/TZ 170 
Wireless WLAN interface.

•

WLAN Subnet Mask: The subnet of the SonicWALL TZ 50 Wireless/TZ 150 Wireless/TZ 170 
Wireless WLAN interface.