SonicWALL 3500 Benutzerhandbuch
SonicWALL NSA 5000/4500/3500 Getting Started Guide
Page 35
Configuring L2 Bridge Mode
This section provides instructions to configure the SonicWALL
NSA appliance in tandem with an existing Internet gateway
device. This section is relevant to users following deployment
scenario C.
NSA appliance in tandem with an existing Internet gateway
device. This section is relevant to users following deployment
scenario C.
This section contains the following sub-sections:
•
•
•
Connection Overview
Connect the X1 port on your SonicWALL NSA Series to the
LAN port on your existing Internet gateway device. Then
connect the X0 port on your SonicWALL to your LAN.
LAN port on your existing Internet gateway device. Then
connect the X0 port on your SonicWALL to your LAN.
Configuring the Primary Bridge Interface
The primary bridge interface is your existing Internet gateway
device. The only step involved in setting up your primary bridge
interface is to ensure that the WAN interface is configured for a
static IP address. You will need this static IP address when
configuring the secondary bridge.
device. The only step involved in setting up your primary bridge
interface is to ensure that the WAN interface is configured for a
static IP address. You will need this static IP address when
configuring the secondary bridge.
Note:
The primary bridge interface must have a static IP
assignment.
SonicWALL NSA
Network Gateway
L2 Bridge Link
LAN
Internet or
LAN Segment 2
NSA
Network Resources