Avaya 03-300430 Benutzerhandbuch

This test verifies that the NPE channel for the port being tested can correctly perform the 
conferencing function.

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

1000

ABRT

System resources required to run test are not available. The port may be 
busy with a valid call.

1. Use display port location to determine the station extension. 

Use status station to determine the service state of the port. If the 

port is active, wait until it is idle before retesting.

2. Retry the command at 1-minute intervals up to 5 times.

1004

ABRT

The port was seized by a valid call during the test. The test has been 
aborted.

1. Use display port location to determine the station extension. 

Use status station to determine the service state of the port. If the 

port is active, wait until it is idle before testing.

2. Retry the command at 1-minute intervals up to 5 times.

1018

ABRT

Test disabled by administration. This only applies to analog stations.

1. To enable the test for the analog station being tested, enter change 

station extension and enter y in the Test field.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

Could not allocate the necessary system resources for this test.

1. Retry the command at 1-minute intervals up to 5 times.

Any

FAIL

The NPE of the tested port did not conference the tones correctly. This 
causes noisy and unreliable connections.

1. Replace the circuit pack.

PASS

The port can correctly conference multiple connections. User-reported 

troubles on this port should be investigated by using other port tests and by 

examining station, trunk, or external wiring.